Iron and Hardness in Washington County: Understanding Aquifer 110SDMS Water Quality Variability

$1,041.85 $2,195.00
All In One Iron & Sulfur And Water Softener
✓ Free shipping in the USA · ✓ 90-day returns · ✓ Secure checkout
Seasonal and Multi-Year Variation in Washington County’s Aquifer Data
The U.S. Geological Survey monitored groundwater from aquifer 110SDMS in Washington County, ID, over a one-year span from mid-2010 to mid-2011. Sampling occurred in three wells ranging from 39 to 140 feet deep. Hardness, expressed as the combined concentration of calcium and magnesium, showed a median of 97.0 mg/L with a measured range between 41.8 and 348.0 mg/L during that timeframe. This range demonstrates natural variability over seasons or longer periods, reflecting how local geology and hydrology influence mineral dissolution and water composition over time.
Important Information to Record Before Seeking Treatment Advice
Before deciding on treatment options, note any recent water tests for your household water, including date, sample depth if from a well, and detailed hardness and iron levels. Document any water usage patterns or changes, and whether water clarity, taste, or staining issues have appeared. This data helps distinguish between area-level findings and specific household conditions, which may vary widely despite the general aquifer profile.
Household Signs Related to Iron and Hardness Issues
Common symptoms of elevated iron and hardness include water that leaves mineral scale on fixtures, causes reddish or brown staining, or affects soap lathering and appliance efficiency. However, not all discoloration or hardness-like effects point solely to these minerals. Some water characteristics may stem from other factors. Absence of these symptoms does not guarantee low iron or hardness, requiring testing for confirmation.
Meaning of ‘Detected,’ ‘Median,’ and ‘Range’ in the Sampling Record
Detected means measured levels of minerals were found in all three sampled wells; it is not a safety or health violation. The median value of 97.0 mg/L represents the middle value of hardness across samples, while the range of 41.8 to 348.0 mg/L shows the lowest and highest levels found. These figures represent the broader aquifer and not any single household. None of the samples exceeded federal health-based limits for hardness or iron.
Consequences of Leaving Elevated Iron and Hardness Untreated
If higher hardness and iron remain untreated, households may experience mineral buildup on plumbing and appliances, leading to reduced efficiency or damage over time. Staining on sinks and laundry can cause aesthetic concerns. Persistent scale can complicate cleaning and increase maintenance efforts. These outcomes are typical for untreated hard and iron-rich water but do not imply health risk.
What a Certified Laboratory Test Reports and How to Understand It
A certified lab test on your actual household water will provide precise iron and hardness concentrations specific to your supply. Results come with units consistent with government sampling, allowing comparison to the area median and range but focused on your water. Knowing exact levels enables selecting a properly sized treatment system to address your needs without under- or oversizing.
For households in Washington County dealing with iron and hardness, the Fleck Iron + Hard Water (Well) System offers a documented solution with a grain capacity of 32,000. This system ships ready to configure and is designed to address problems identified by local water quality while matching household demand based on test results.
The critical step is ordering a certified laboratory analysis of your well or tap water specifically for iron and hardness. The test result will determine whether treatment is appropriate and help select the right capacity system to handle your water’s mineral content efficiently.
Where this information comes from
Source: USGS groundwater sampling. Sampled 2011-07-27. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.
On record: U.S. Geological Survey sampling of Hardness, Ca, Mg in the 110SDMS aquifer (Washington County): 3 results from 3 wells, median 97.0 mg/L, range 41.8-348.0 mg/L; none above any federal threshold
