Pentair Arsenic Filter

Buy Now

View full details

This week, your household must decide how to address arsenic in your water supply following the failure of existing treatment equipment.

If you notice symptoms that may relate to arsenic presence

Arsenic typically does not cause noticeable taste, smell, or appearance changes in water, so symptoms such as discoloration or odor are unlikely to be related to arsenic. The absence of obvious signs does not mean arsenic is absent. Because arsenic is colorless and tasteless, the only reliable way to detect it is through water testing.

If you plan to seek treatment advice, record key household and water system details first

• Note your household water source, including well depth and construction details if available.
• Record the model and age of your previous water treatment equipment that failed.
• Gather any past water quality reports or tests performed on your water supply.
• List which water fixtures or appliances have shown signs of issues since treatment equipment failed.

If you want to understand which parts of your plumbing or appliances may be impacted first

Arsenic presence primarily poses a health concern rather than damaging fixtures or appliances. Unlike minerals that cause buildup or staining, arsenic does not typically affect water heaters, dishwashers, or plumbing physically. The main consideration is ensuring your drinking and cooking water is safe, which means point-of-use treatment devices or whole-house filters targeting arsenic may be necessary.

If you are reviewing a certified laboratory test report for arsenic

The report will measure arsenic concentration in micrograms per liter (ug/L). In Hampden County's 112SRFD aquifer, government sampling from 2011 to 2017 found arsenic detected in 7 of 14 samples at levels between 0.06 and 6.5 ug/L. The median value was 0.09 ug/L. None of these measurements exceeded the federal arsenic threshold for drinking water safety. A single test of your own water is needed to determine your home's exact arsenic concentration since area averages cannot specify your well.

If you consider that these findings are based on a limited sample size of wells

The data comes from 14 samples taken from 10 wells ranging in depth from 8 to 141 feet. While valuable to understand local aquifer tendencies, this small dataset cannot capture variability in every well. Individual well arsenic levels may be higher or lower than the regional median. Testing your water is critical for precise knowledge.

If you want to distinguish arsenic concerns from other water quality issues often confused with it

Arsenic differs from iron or manganese by being tasteless and colorless and not causing staining or clogging. Unlike hardness minerals, it does not cause scale buildup. The challenges with arsenic relate solely to health-based water quality, unlike aesthetic or operational issues associated with other constituents.

Do not assume that because arsenic was detected in area wells, your own water contains arsenic at the same level or poses a health risk without an actual test. Area data supports awareness but cannot replace personalized water analysis.

To address arsenic after treatment equipment failure, consider the Pentair Arsenic Filter, which ships ready to configure for household water arsenic removal.

Where this information comes from

Source: USGS groundwater sampling. Sampled 2017-08-10. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.

On record: U.S. Geological Survey sampling of Arsenic in the 112SRFD aquifer (Hampden County): 14 results from 10 wells, median 0.09 ug/L, range 0.06-6.5 ug/L; none above any federal threshold