Pentair Uranium & Radium System

Buy Now

View full details

Separating Plumbing Effects from Regional Groundwater Conditions

Plumbing material does not influence uranium or radium levels

Uranium and radium originate from natural minerals in the local aquifer, not from household plumbing materials or their age. Unlike some metals or corrosive elements that can leach from pipes, uranium and radium concentrations are determined by the water source itself.

Age or condition of pipes doesn't change uranium-radium content

While older plumbing can affect other water quality aspects, uranium and radium levels remain linked to the sampled groundwater. Plumbing affects may influence taste or appearance but do not create or reduce uranium or radium presence.

Measured Uranium Levels Compared to Federal Guidelines

Government sampling in Marshall County aquifer 124TLLT shows low uranium detections

Six samples taken from three wells in the county’s 124TLLT aquifer found uranium ranging from 0.007 to 0.041 micrograms per liter, with a median of 0.0215 micrograms per liter. Four results detected uranium; two were below reporting limits.

No samples exceeded federal uranium concentration thresholds

This government data confirms that measured uranium in sampled wells does not surpass any federal standard for drinking water safety. This means no known regulatory violation was recorded in these locations.

Detection alone is not a health or safety determination

Detecting uranium means measurement instruments found its presence, but this does not signify unsafe water or a violation. Actual risk and compliance depend on specific concentrations and regulatory limits.

How the Pentair Uranium & Radium System Addresses These Constituents

Treatment system uses specialized removal technology

The Pentair Uranium & Radium System targets uranium and radium through processes that reduce their concentrations in household supply water, effectively managing radionuclide levels in residential settings.

System capacity supports substantial contaminant removal

With a grain capacity of 32,000, this equipment is designed to handle uranium and radium loads typical for affected residential wells, providing ongoing mitigation where elevated levels are confirmed.

Differentiating Uranium-Radium from Commonly Confused Issues

Uranium-radium presence differs from hardness or iron concerns

Unlike hardness or iron, uranium and radium are radioactive elements and require distinct testing and treatment methods. Their detection does not correlate with water hardness or iron staining.

Not related to microbial or aesthetic water problems

Uranium and radium are unrelated to bacteria, taste, odor, or common aesthetic issues; addressing one does not resolve the others.

Data Scope: Number of Samples, Wells, and Implications

Sampled data comes from three wells, six total measurements

Information reflects six analyses from three separate wells between 2011 and 2022, with well depths around 33 to 38 feet. This sample size offers regional insight but not a direct measure of any specific well.

Limited data suggests careful interpretation

While informative, this relatively small data set means individual wells might vary. Homeowners should not assume their water matches these readings without personal testing.

Reading Regional Uranium Data as a Homeowner

Median uranium level provides a typical regional reference point

The median value of 0.0215 micrograms per liter reflects the central tendency of measured uranium in the area but is not a household-specific measurement.

Range indicates natural variability in groundwater uranium

Range from 0.007 to 0.041 micrograms per liter shows variability that can occur among wells in the aquifer, underscoring the need for well-specific analysis.

Final Recommendation: Obtain a Direct Test for Uranium-Radium

The only way to determine your household water uranium and radium levels is to request an accredited laboratory test of your well or water supply. Testing will provide accurate concentrations against which to decide on treatment necessity.

If results confirm uranium or radium at elevated levels, the Pentair Uranium & Radium System offers a documented technology to reduce these constituents effectively, supporting safe and compliant drinking water.

Where this information comes from

Source: USGS groundwater sampling. Sampled 2022-06-02. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.

On record: U.S. Geological Survey sampling of Uranium in the 124TLLT aquifer (Marshall County): 6 results from 3 wells, median 0.0215 ug/L, range 0.007-0.041 ug/L; none above any federal threshold