WSP Whole House Uranium & Radium Reduction System

Buy Now

View full details

What to Record from Your Uranium or Radium Water Test Report

When you receive laboratory results for uranium or radium in your household water, note the specific measured concentration reported in micrograms per liter (ug/L). Record the sample date, the water source tested (such as your private well), and whether the report references detection limits or reporting limits. These details will be essential for expert advice or when considering treatment options.

Interpreting 'Detected,' Median, and Range in Butler County Aquifer Sampling

The U.S. Geological Survey sampled 12 wells in Butler County's 112OTSH aquifer from 2010 to 2020, finding uranium concentrations detected in all 15 samples with values between 0.224 and 1.3 ug/L. The median value was 0.505 ug/L. This means instruments found uranium present at levels measurable within this range and central tendency in that area. However, these are regional results—your own water may differ, and detection does not imply a health violation. Importantly, none of these sampled concentrations exceeded federal uranium safety thresholds.

Steps to Narrow Down Your Residential Uranium-Radium Water Issue

First, check for any obvious sources or changes near your water source that might cause differences in uranium or radium levels. Then, conduct basic water quality tests for indicators such as pH and total dissolved solids before proceeding. Finally, obtain a certified laboratory analysis of your specific water supply for uranium and radium concentrations. This step is critical since area data cannot substitute for your own well's results.

Sample Size and Geographic Context Behind Butler County Uranium Measurements

The USGS data for uranium in Butler County's aquifer is based on 15 samples from 12 wells between 32 and 92 feet deep, collected over a 10-year period. This sampling provides a snapshot of regional groundwater conditions but is limited in scope. Individual water sources may vary outside this range. The relatively small sample size and broad geographic area mean that localized variations cannot be identified without additional testing.

Potential Outcomes if Uranium-Radium Levels in Water Remain Untested or Untreated

Long-term consumption of water with uranium or radium concentrations above recommended guidelines can contribute to health risks identified by federal agencies. However, the regional data indicate no exceedances in Butler County’s aquifer samples. Still, without testing your own water, it is impossible to determine whether extended exposure could be a concern. Addressing elevated uranium or radium requires appropriate treatment to reduce these elements from your water.

What You Should Not Infer from Butler County Area Uranium-Radium Data

Area groundwater sampling results show detected uranium at certain levels but do not establish that your household water has these concentrations. Detection is not a regulatory violation or health finding. The data do not reveal radium measurements specifically. Avoid assuming the presence, absence, or safety of uranium or radium in your water solely based on this regional information. Testing your water and considering options like the Pentair Uranium & Radium System, which ships ready to configure and offers 32,000 grain capacity for treatment, can provide targeted solutions based on your unique water quality.

Where this information comes from

Source: USGS groundwater sampling. Sampled 2020-11-18. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.

On record: U.S. Geological Survey sampling of Uranium in the 112OTSH aquifer (Butler County): 15 results from 12 wells, median 0.505 ug/L, range 0.224-1.3 ug/L; none above any federal threshold