C-Series Top Basket 1.050 Inch for Mineral Tanks — TDB1050-FMC, C-Series Top Bskt 1.050", FM, D1225-03
Samples and Wells Behind Regional Water Quality Data
Number of Samples and Wells
Seven water samples were collected from four separate wells in Tangipahoa Parish's aquifer 112UPTC between August 2013 and May 2015.
Depth of Sampled Wells
The sampled wells ranged from 90 to 145 feet deep, representing common groundwater sources in the area.
Implications of a Small Sample Size
While these samples provide a regional snapshot, the limited number means individual well water may vary. Personal water testing is necessary to confirm specific conditions.
How Treated Water Differs at the Tap with the C-Series System
Reduction of Residue That Causes Spotting
The C-Series Spotty Dishes & Glassware System reduces minerals in water that can leave spots and films on dishes after washing.
Effect on Dish Appearance
After treatment, dishes typically appear cleaner with fewer visible spots or cloudy film.
Impact on Water Use Efficiency
This system can improve the effectiveness of detergents and rinse cycles, potentially decreasing water and energy use in dishwashing.
How Minerals Enter Groundwater in Tangipahoa Parish Aquifer 112UPTC
Natural Mineral Presence
Calcium and magnesium naturally dissolve into groundwater as it moves through mineral-bearing soils and rock in the aquifer.
Regional Geology Influence
The local geology of Tangipahoa Parish contributes to the moderate appearance of these minerals in sampled well water.
Human Impact on Water Composition
There is no evidence from these samples that human activities have significantly altered mineral concentrations in the aquifer.
Understanding 'Detected', 'Median', and 'Range' in Water Sampling
Detected Means Measured Presence
All seven samples showed calcium and magnesium levels above laboratory detection limits, indicating these minerals are present but not necessarily in problematic amounts.
Median Level Indicates Typical Concentration
The median calcium and magnesium hardness is 5.5 mg/L, the middle value among all samples, which helps represent typical water quality in the area.
Range Shows Variability Across Samples
Sample values ranged from 3.67 to 8.72 mg/L, showing some variation that can occur from well to well or over time.
Fixtures and Appliances Affected First by Spotting
Dishwashers and Glassware
Mineral residues are most noticeable on dishes and glasses, where spotting and thin films commonly appear.
Faucets and Sinks
Minerals can leave visible deposits on fixtures, affecting their appearance.
Other Household Appliances Using Water
While less visible, minerals may accumulate in appliances like coffee makers and ice machines, potentially affecting performance.
What the Regional Data Does Not Establish
The regional water sampling results do not determine the mineral content of your household well or tap water. To choose the best equipment for spot-free dishes, testing of your own water is essential. The presence of these minerals in the area does not mean your water will have the same levels or cause spotting without additional factors. The C-Series Spotty Dishes & Glassware System ships ready to configure and is designed to address mineral-related spotting when such conditions are confirmed.
Where this information comes from
Source: USGS groundwater sampling. Sampled 2015-05-06. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.
On record: U.S. Geological Survey sampling of Hardness, Ca, Mg in the 112UPTC aquifer (Tangipahoa Parish): 7 results from 4 wells, median 5.5 mg/L, range 3.67-8.72 mg/L; none above any federal threshold