36 Steel Tanks - Twin Unit Skid

Buy Now

View full details

If you see spots but think it's just detergent

Spots on dishes after washing often lead operators to blame detergents or rinse aids. While these products help, spots frequently result from minerals dissolved in water. In Pawnee County, samples from aquifer 322VNSS show calcium and magnesium concentrations common enough to produce visible spotting. Recognizing this source helps target the right treatment rather than adjusting detergents alone.

If you want to remove the mineral cause of spots, what does treatment do?

The 36 Steel Tanks - Twin Unit Skid uses commercial system skid technology to address the minerals responsible for spots, primarily calcium and magnesium. It conditions water by removing or neutralizing these minerals before the water reaches the dishwasher. This control reduces mineral deposits on dishes, enabling a spot-free finish without depending on chemical additives.

If you operate a commercial facility, what specific factors affect your choice of system?

Commercial operators must consider water volume, peak usage times, and cleaning standards higher than residential users. This means ensuring treatment capacity matches daily water demand and that the system can maintain consistent performance under heavier loads. Unlike household units, commercial skids like the 36 Steel Tanks Twin Unit are designed to handle these larger and more variable requirements efficiently.

If you want to match your water demand to treatment capacity, what should you evaluate?

Evaluate your facility’s daily and peak water use carefully. This includes dishwashing cycles per day, water temperature, and rinse frequency. The treatment system should offer enough capacity to handle total daily consumption with margin for peak loads. Overestimating demand leads to unnecessary costs, while underestimating can diminish treatment effectiveness and cause spotting to continue.

If you wonder what the terms detected, median, and range mean for your water quality

Government sampling in Pawnee County’s aquifer 322VNSS recorded calcium and magnesium presence in all five wells sampled between March and May 2018. The median concentration was 202.0 mg/L, with a range between 95.4 mg/L and 263.0 mg/L. Detected means minerals were measured; median is the middle value among samples; range defines the spread from lowest to highest measurement. These results do not imply your water matches any specific value.

If spot-causing minerals go untreated over years, what happens?

Leaving minerals untreated can lead to persistent spotting on dishes, which affects visual cleanliness and may require extra cleaning effort. Over time, mineral buildup can accumulate within dishwashers, potentially increasing maintenance needs and reducing efficiency. Consistent treatment helps maintain dish appearance and protects equipment without drastic interventions.

If you use the 36 Steel Tanks - Twin Unit Skid, how does your water at the tap improve?

Treated water will have significantly reduced calcium and magnesium responsible for spots on dishes. This results in clearer glassware and cutlery, reducing the need for extra rinsing or chemical adjustments. The water's quality supports achieving commercial standards for dish appearance while simplifying dishwasher maintenance.

This information summarizes mineral presence found in Pawnee County wells drawing from aquifer 322VNSS by the U.S. Geological Survey from March to May 2018. For further details, consult the government source at https://waterdata.usgs.gov/monitoring-location/361814096470601/.

Where this information comes from

Source: USGS groundwater sampling. Sampled 2018-05-11. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.

On record: U.S. Geological Survey sampling of Hardness, Ca, Mg in the 322VNSS aquifer (Pawnee County): 5 results from 5 wells, median 202.0 mg/L, range 95.4-263.0 mg/L; none above any federal threshold