Fleck Soap Won't Lather System

Buy Now

View full details

The U.S. Geological Survey conducted groundwater sampling in Lake County, Indiana, specifically targeting aquifer 110QRNR, with results shedding light on water characteristics relevant to soap lather problems. Across 22 samples from 18 wells taken between July 2011 and June 2021, the concentration of certain minerals linked to water hardness was consistently detected.

What 'Detected', 'Median' and 'Range' Mean in the Sampling Record on This Page

Every tested sample from 8 to 18 feet deep showed measurable levels of calcium and magnesium compounds, minerals that contribute to water hardness. The median value recorded was 268.5 mg/L, with individual results spanning from a low of 133.0 mg/L to a high of 417.0 mg/L. "Detected" indicates these minerals were found in all samples; it does not indicate any regulatory noncompliance or health risk but confirms their presence in local groundwater.

How Seasonal or Multi-Year Variation Shows in the Record

The data encompasses a decade-long timespan, revealing both persistent presence and a substantial range of mineral concentrations. Samples from different seasons and years demonstrate that fluctuations in mineral levels are common but consistently fall within the recorded range. This suggests that households in the area can expect some variability but likely within these bounds over time.

What the Reader Should Write Down Before Asking Anyone for Treatment Advice

Before exploring treatment options, it is essential to conduct a specific water test of your own household supply to determine actual mineral concentrations affecting soap lathering. Note the hardness-related measurements (calcium and magnesium) and any symptoms noticed in daily water use. This information will help clarify whether your individual water conditions align with the regional data and guide tailored recommendations.

The Household or Facility Symptoms That Do and Do Not Point to This Problem

Symptoms related to calcium and magnesium include difficulty in achieving soap lather and possible residue buildup on surfaces or skin. However, soap lather issues can also arise from other factors such as soap composition, water temperature, and plumbing materials. Conversely, symptoms like unusual taste or staining are not necessarily linked directly to these minerals based on the regional data.

What the Measured Range Means Against the Relevant Federal Standard, and What It Does Not Mean

None of the 22 results exceeded any federal guidelines or safety thresholds. The minerals detected fall within acceptable ranges and do not represent a health violation. These measurements primarily relate to aesthetic concerns such as soap effectiveness and minor buildup, not to drinking-water safety or legal compliance.

How the Treated Water Differs at the Tap Once the Documented Technology Is in Place

When using the Fleck Soap Won't Lather System, water mineral content responsible for inhibiting soap foam is addressed directly. This system is designed to condition water by targeting the minerals affecting soap lather, leading to noticeably improved soap performance and reduced residue. Water at the tap after treatment will generally allow soap to lather more readily, reducing the frustration associated with hard water effects.

For households in Lake County dealing with soap lather challenges consistent with regional groundwater mineral patterns, the Fleck Soap Won't Lather System ships ready to configure and offers a focused solution that correlates with the documented demand indicated by area sample data.

Where this information comes from

Source: USGS groundwater sampling. Sampled 2021-06-22. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.

On record: U.S. Geological Survey sampling of Hardness, Ca, Mg in the 110QRNR aquifer (Lake County): 22 results from 18 wells, median 268.5 mg/L, range 133.0-417.0 mg/L; none above any federal threshold