Starting with Simple Checks Before Testing Radon in Water
If you notice an unusual taste or smell in your tap water, it’s reasonable to consider the possibility of radon or other issues. Begin by verifying plumbing fixtures and water sources for common causes that might affect flavor or odor. Using a home water test kit can reveal basic water quality parameters, but for radon, a laboratory analysis of your private well or water supply is necessary to know the radon level precisely.
Understanding 'Detected', 'Median', and 'Range' in USGS Radon Data for Aquifer 112SNTF
Government sampling in Doña Ana County's aquifer 112SNTF shows that radon-222 was detected in all 34 results from wells between 147 and 1322 feet deep. The median value was 325.0 picocuries per liter (pCi/L), with results ranging from 91.0 to 2180.0 pCi/L. Detection here means that instruments found radon; it does not imply a violation or unsafe condition by itself. These statistics reflect the regional groundwater and not your specific water supply.
Potential Outcomes of Leaving Radon in Water Untreated Over Time
Radon in water primarily presents a risk when it releases into indoor air during water use. Without management, long-term exposure to radon gas emanating from water can contribute to indoor radon levels. This could increase inhalation exposure, which is the main route of concern. Direct consumption of radon in water poses much less risk. Awareness and appropriate response to radon detection in your home water reduce potential risks over time.
Differences Between Public Water System Records and Private Well Testing
Public water utilities in Doña Ana County regularly monitor for radon and report results publicly. These records provide general information about community water quality but do not address individual household conditions. Private wells, however, are not covered by public testing, so a private well owner needs to conduct their own radon test through an accredited laboratory to understand their specific water condition. Thus, public system data and private well testing serve complementary but distinct roles.
Seasonal and Multi-Year Variations in Radon Levels Recorded in Aquifer 112SNTF
The USGS data for radon in Doña Ana County aquifer 112SNTF were collected from November 2010 through July 2015. Over this period, radon levels showed variation from 91.0 to 2180.0 pCi/L across sampled wells, reflecting geological and hydrological changes in the aquifer. Radon concentration in groundwater can fluctuate with factors such as water table level, temperature, and flow patterns. This variability means a single test at one time may not capture all fluctuations in your water's radon level.
Summary of Radon Sampling Scope and Where to Find Official Data
All referenced measurements come from 34 samples taken in Doña Ana County’s aquifer 112SNTF from 31 wells at varying depths. These figures give a picture of radon presence in the regional groundwater but are not a substitute for testing your own water. For official data and updates, refer to the US Geological Survey groundwater data portal.
Should testing reveal elevated radon levels in your home water, a Fleck Radon in Water Filter ships ready to configure for household mitigation, offering a documented approach to reduce radon before use.
Where this information comes from
Source: USGS groundwater sampling. Sampled 2015-07-08. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.
On record: U.S. Geological Survey sampling of Radon-222 in the 112SNTF aquifer (Doña Ana County): 34 results from 31 wells, median 325.0 pCi/L, range 91.0-2180.0 pCi/L; none above any federal threshold
- ✓ 90-Day Money-BackNo restocking fees — return within 90 days.
- ✓ Manufacturer WarrantyGenuine Fleck · Pentair · VIQUA equipment.
- ✓ Free Expert SizingTalk to a specialist and buy the right system the first time.