Did nitrate appear in Clay County’s aquifer 111ALVM groundwater sampling, and what do terms like ‘detected,’ ‘median,’ and ‘range’ mean here?
Government groundwater sampling in Clay County's aquifer 111ALVM found nitrate (reported as nitrite in related tests) in many wells but always at low levels. “Detected” means instruments measured nitrite in 74 of 110 samples from nine wells; “median” is the middle value of 0.006 mg/L, and “range” shows values from 0.001 to 0.027 mg/L. These samples represent area wells 36 to 105 feet deep, not any one home’s water.
How often should nitrate filtration equipment be maintained?
The Autotrol Nitrate & Nitrite (Well) Filter ships ready to configure for home use and requires routine care to keep it effective. Maintenance intervals depend on household water characteristics and usage, but regular checks and media replacement as advised in product guidance ensure continued nitrate reduction without service interruption.
How many wells and samples make the nitrate data reliable for Clay County, and what does a small sample set imply?
The data comes from 110 samples taken from nine wells over sixteen years. While this offers a solid overview of nitrate levels in the aquifer, individual wells may vary. Smaller sample sizes or fewer wells limit confidence in data representativeness, so personal water testing is needed to know your household’s exact nitrate level.
What should be considered about nitrate and water use in large households, second homes, or seasonal properties?
Higher water demand in large households increases total nitrate exposure if concentrations are elevated, making filtration capacity an important consideration. For second or seasonal homes, nitrate levels may fluctuate with aquifer conditions, so testing before use and ensuring filtration readiness is recommended to maintain water quality consistently.
What does the measured nitrate range mean relative to federal safety thresholds, and what does it not reveal?
The highest nitrate-related nitrite concentration recorded in this area’s samples was 0.027 mg/L, well below any federal thresholds for health safety. This confirms no samples in these wells exceeded regulatory action levels. However, it doesn’t guarantee that an individual well will have the same or lower nitrate, nor does it assess other water quality factors.
What does a certified lab report for nitrate typically include, and how should a homeowner interpret it?
A certified laboratory report shows nitrate concentration as mg/L, often reported alongside nitrite measurements. It defines detection limits and may flag values above certain advisory or regulatory thresholds for nitrate. Homeowners should compare test results to federal guidelines and understand that only their own testing reveals their specific water quality.
For households in Clay County relying on aquifer 111ALVM water, the Autotrol Nitrate & Nitrite (Well) Filter provides a documented method to reduce nitrate exposure. Choosing this system based on your own water testing and daily water use helps ensure effective treatment tailored to your home’s needs.
Where this information comes from
Source: USGS groundwater sampling. Sampled 2026-05-12. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.
On record: U.S. Geological Survey sampling of Nitrite in the 111ALVM aquifer (Clay County): 110 results from 9 wells, median 0.006 mg/L, range 0.001-0.027 mg/L; none above any federal threshold
- ✓ 90-Day Money-BackNo restocking fees — return within 90 days.
- ✓ Manufacturer WarrantyGenuine Fleck · Pentair · VIQUA equipment.
- ✓ Free Expert SizingTalk to a specialist and buy the right system the first time.