Pentair Orange Iron & Rust Stains Filter

Buy Now

View full details

How the Pentair System Removes Iron and Rust

Filtration and Oxidation Process

The Pentair Orange Iron & Rust Stains Filter uses a technology designed to capture iron particles and convert soluble iron into a filterable form. This method reduces visible rust staining and water discoloration commonly caused by iron in household water supplies.

Readiness for Immediate Setup

This system ships ready to configure, allowing households to implement it quickly without specialized on-site work. It is designed to integrate with existing water lines to address iron-related water aesthetics.

Additional Considerations for Commercial and Industrial Use

Water Volume and Flow Rate Demands

Commercial and industrial settings typically require higher treatment capacity due to elevated water volumes. These users often need to confirm that any filtration system accommodates peak flow rates to maintain adequate iron removal.

Regulatory Compliance and Reporting

Unlike households, commercial operators may have regulatory reporting duties related to iron concentrations depending on their use and discharge. They must verify that treatment meets any applicable local guidelines beyond aesthetic concerns.

Information to Record Before Seeking Treatment Advice

Water Test Results from Your Specific Well or Source

Since regional sampling does not reveal your well’s precise iron level, obtaining a current water analysis report for your property is essential. Note the iron concentration and any other relevant parameters.

Age and Condition of Existing Equipment

Detail the type and last maintenance date of current water treatment equipment to understand possible reasons for its failure and to plan for replacement or upgrade.

Interpreting Terms in the Osage County Sampling Record

Meaning of "Detected"

"Detected" means iron was measured at a level above the instrument’s reporting limit in the sampled wells; it is not an indication of a health violation.

Understanding "Median" and "Range"

The median iron concentration was 0.035 mg/L among five wells sampled, with individual results ranging from 0.02 to 11.0 mg/L. This shows variation in iron presence within the aquifer but does not specify the actual concentration in your well.

How Iron Enters Osage County Groundwater

Natural Geology Influence

Iron naturally occurs in the local geology and can dissolve into groundwater as it moves through iron-bearing rock formations, especially in wells ranging from 21 to 70 feet deep, like those sampled.

Impact of Well Depth and Construction

Well depth and how it is constructed can affect iron concentrations since shallow or poorly sealed wells may allow surface minerals or sediments to influence water quality.

What the Measured Iron Range Means Relative to Federal Guidelines

Aesthetic Secondary Standard

One of the five sampled wells showed iron above the secondary standard of 0.3 mg/L, a threshold related to taste and staining. This is not a health-based standard and does not indicate unsafe water.

Implications for Household Water Quality

Iron levels below or near the secondary standard typically cause no health concerns but may cause water discoloration and staining on fixtures or laundry.

What Not to Conclude from the Area Sampling Data

Do Not Assume Your Water’s Iron Level

Area-wide sampling provides a general idea of iron presence in Osage County aquifer 110ALVM but cannot determine the exact iron concentration in your household water without specific testing.

Detection Does Not Equal a Health Risk

Detecting iron, even at elevated levels, does not mean your water is unsafe. Iron primarily affects aesthetics and household systems, which can be managed effectively with technology like the Pentair Orange Iron & Rust Stains Filter.

Where this information comes from

Source: USGS groundwater sampling. Sampled 2016-09-14. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.

On record: U.S. Geological Survey sampling of Iron in the 110ALVM aquifer (Osage County): 5 results from 5 wells, median 0.035 mg/L, range 0.02-11.0 mg/L; 1 above an AESTHETIC secondary standard only (secondary standard 0.3 mg/L (aesthetic)) - not a health finding