Dry Skin Concerns in Pottawatomie County: Understanding Water Variations and Whole-Building Treatment

$3,946.99
20 Steel Tanks - Twin Unit Skid
✓ Free shipping in the USA · ✓ 90-day returns · ✓ Secure checkout
If You Consider Seasonal and Multi-Year Water Quality Variation in Pottawatomie County, What Does the USGS Record Show?
The U.S. Geological Survey sampled six wells from aquifer 317GBWG in Pottawatomie County between September 2011 and March 2013. These samples reveal variations in mineral concentrations over approximately a year and a half. The hardness, expressed as combined calcium and magnesium levels, ranged from 25.8 to 190.0 mg/L with a median value of 76.5 mg/L. This range indicates natural fluctuations in mineral content affecting groundwater quality over time and depth, as wells ranged from 110 to 200 feet deep.
Such variation is typical in regional aquifers due to geological factors and seasonal changes. When assessing potential causes of dry skin linked to water quality, understanding this temporal and spatial variability is important because water drawn from different depth wells or at different times may differ in mineral content.
If You Wonder What 'Detected', 'Median', and 'Range' Mean in This Sampling Record, How Should You Interpret Them?
In the USGS dataset, 'detected' means the measuring instruments identified hardness minerals in all six wells sampled. 'Median' is the middle value of the hardness measurements when ordered, which here is 76.5 mg/L, representing a typical concentration in this area. The 'range' from 25.8 to 190.0 mg/L shows the lowest and highest measured hardness across the wells.
None of these measurements were above any federal thresholds, meaning the regional groundwater complies fully with regulations concerning these minerals. However, these figures do not address a specific well’s water quality. Individual well testing is required to confirm your building’s water characteristics and how they relate to skin dryness concerns.
If You Notice Dry Skin Primarily Affects Certain Areas or Processes in Your Commercial Building, Which Water-Using Fixtures or Appliances Are Often Impacted First and Why?
Fixtures and appliances that use large volumes of water or involve frequent direct skin contact often reveal the effects of water mineral content earliest. These include:
- Public or employee showers, where mineral content can reduce water’s natural softness and affect skin moisture.
- Sink faucets in break rooms or restrooms, which are commonly used for hand washing.
- Humidifiers or misting systems reliant on water supply, potentially influenced by mineral buildup.
Higher mineral concentrations can contribute to dryness sensations, as they alter water’s interaction with skin oils. Understanding which points of use show issues helps target water treatment efforts effectively for the entire building.
If You Decide to Obtain a Certified Laboratory Test for Your Building’s Water Regarding Hardness Minerals, What Will the Report Show and How Should You Read It?
A certified laboratory test measures the specific levels of calcium and magnesium ions contributing to hardness in your water supply. The report typically lists results in milligrams per liter (mg/L), similar to the USGS measurements. It shows actual concentrations in your water, unlike area-wide sampling.
When reading the report, compare your results to the median and range of the Pottawatomie County aquifer data to understand if your water is relatively soft or hard within the local context. Note that detections below federal thresholds indicate the water meets regulatory standards but do not directly address skin dryness.
If You Consider a Larger Commercial Building or One with Seasonal Occupancy, How Might Water Quality and Dry Skin Symptoms Change?
In larger buildings, water is often drawn and distributed through extensive plumbing systems, which can affect mineral deposition independently of source water quality. Seasonal occupancy can mean water stagnates in pipes longer, potentially changing how minerals interact with skin during use.
Both scenarios emphasize the importance of whole-building water management rather than point-of-use solutions. Addressing the water feeding the entire system ensures consistent quality and reduces uneven dry skin symptoms across different areas or seasons.
Using dedicated commercial system skids like the 20 Steel Tanks - Twin Unit Skid is a documented method to treat water at scale, optimizing comfort and water quality for all building occupants.
What Should You Not Conclude From the Area Aquifer Data Regarding Dry Skin?
The USGS sampling provides valuable regional water quality context but does not establish your building’s precise water conditions. Mineral levels detected in Pottawatomie County aquifer wells are not violations or indications of unsafe water. Instead, they reflect natural variations within regulatory compliance.
You should not assume your well or municipal supply matches these figures without direct testing. Additionally, dry skin symptoms have multiple causes beyond water hardness alone, including environmental and personal factors. Accurate water testing combined with suitable whole-building treatment tailored to your needs is the best approach to address dry skin concerns effectively.
Where this information comes from
Source: USGS groundwater sampling. Sampled 2013-03-13. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.
On record: U.S. Geological Survey sampling of Hardness, Ca, Mg in the 317GBWG aquifer (Pottawatomie County): 6 results from 6 wells, median 76.5 mg/L, range 25.8-190.0 mg/L; none above any federal threshold
