How many wells and samples back up this water quality data in Yuma County?
The U.S. Geological Survey collected 37 groundwater samples from 36 wells across the Yuma County aquifer area between April 2025 and April 2026. These wells ranged from 25 to 149 feet in depth. While 37 samples may seem limited, this focused data set provides a snapshot of water conditions across the aquifer, not specific to any one home or well. It is important to remember that individual wells can vary significantly from area results.
How should I compare Yuma County’s corrosive water record to nearby counties?
When comparing Yuma County’s aquifer water data to neighboring regions, note that chloride levels—a key marker linked with corrosivity—show a median of 265 mg/L here. Nearby counties may have different chloride ranges depending on geology and water sources, but this does not imply your home’s water will match those concentrations. Regional comparisons offer context but not a direct prediction of household water chemistry.
How does the Fleck Corrosive Water Damaging Pipes Filter address corrosive water problems?
This filter is designed to reduce factors in water that contribute to pipe corrosion. It works by conditioning water to limit the effects of elevated chloride and related minerals known to accelerate pipe wear. By treating water before it enters household plumbing, this system helps protect your pipes and fixtures, extending their lifespan and reducing damage caused by corrosive water conditions commonly found in the Yuma County aquifer.
What do the terms 'detected', 'median', and 'range' mean in the sampling data?
In the Yuma County water data, 'detected' means that instruments measured chloride in all 37 samples; none were below detection limits. The 'median' value of 265 mg/L represents the middle point of the dataset, meaning half the samples measured above and half below this level. The 'range' from 99.3 to 513 mg/L shows the lowest and highest chloride concentrations found among the sampled wells. These figures describe regional water characteristics but do not specify any individual well’s chemistry.
What is the maintenance rhythm for the Fleck Corrosive Water Damaging Pipes Filter?
This system ships ready to configure and is designed for straightforward upkeep. Maintenance intervals depend on water usage and quality but typically involve periodic media replacement and routine checks to ensure effective operation. Proper care helps maintain filtration performance and protects household plumbing from corrosive water impacts over time.
What should you NOT conclude from this area water data? The regional chloride levels do not indicate whether your specific household water is corrosive or not. Only testing your own well water can establish the conditions affecting your plumbing. Additionally, the aesthetic secondary standard related to chloride is not a health-based limit; exceeding it does not mean your water is unsafe. Understanding these key points helps you make informed decisions about treating corrosive water in your home.
Where this information comes from
Source: USGS groundwater sampling. Sampled 2026-04-09. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.
On record: U.S. Geological Survey sampling of Chloride in the aquifer (Yuma County): 37 results from 36 wells, median 265.0 mg/L, range 99.3-513.0 mg/L; 20 above an AESTHETIC secondary standard only (secondary standard 250.0 mg/L (aesthetic)) - not a health finding