If you notice unusual corrosion on pipes or fixtures in your home, you're likely dealing with corrosive water. This condition can gradually damage plumbing components, causing leaks or reduced appliance life. Franklin Parish's groundwater characteristics require careful evaluation before deciding on treatment.
If Your Plumbing Is Older or Made from Sensitive Materials
The risks posed by corrosive water depend not only on local water composition but also on your home's plumbing. Older pipes or certain metals are more vulnerable to degradation from water chemistry. Even if the source water has moderate corrosive tendencies, plumbing materials can significantly affect the degree of corrosion experienced.
If Your Well or Water Source Draws from 50 to 127 Feet Deep
Government groundwater sampling in Franklin Parish aquifer 112MRVA, covering wells between 50 and 127 feet deep, shows varying water quality characteristics. Well depth influences the water's mineral content and corrosivity. The documented sampling provides a regional snapshot but does not define your individual water conditions precisely.
If You Want to Compare Franklin Parish Data with Neighboring Counties
Comparing nearby areas' water quality records can provide context but should be done cautiously. Variations in aquifers, well depths, and sampling methods affect results, so direct comparisons may overstate differences. Focus on local aquifer data like that for Franklin Parish aquifer 112MRVA when evaluating corrosive water potential.
If You're Interpreting Median and Range from 136 Samples Across 38 Wells
The US Geological Survey's data for Franklin Parish includes 136 chloride concentration results from 38 wells, with a median of 201.5 mg/L and a wide range from 5.44 to 3380.0 mg/L. While chloride influences corrosion and taste, these regional figures are not a substitute for testing your water. They indicate the variable natural conditions that can contribute to corrosivity.
If You're Considering the Number of Samples Behind These Figures
The confidence in regional water quality data increases with sample size. Here, 136 samples from 38 wells provide reasonable coverage within the aquifer but cannot capture all localized conditions. Smaller sample sets from your own well or neighborhood might miss some variability, so testing your water directly is essential to understand corrosivity fully.
If You Want a Treatment Option to Address Corrosive Water
The Fleck Corrosive Water Damaging Pipes Filter is designed to reduce the effects of corrosive water before it damages plumbing. This system ships ready to configure, providing a practical means to neutralize damaging constituents in your water supply. It specifically targets the factors contributing to pipe corrosion documented for your area's groundwater.
Ultimately, the single most important step is to have your home's water professionally tested to measure the actual corrosive elements present. Results from this test will guide whether the Fleck Corrosive Water Damaging Pipes Filter or another approach is appropriate for your household’s water treatment needs.
Where this information comes from
Source: USGS groundwater sampling. Sampled 2025-05-15. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.
On record: U.S. Geological Survey sampling of Chloride in the 112MRVA aquifer (Franklin Parish): 136 results from 38 wells, median 201.5 mg/L, range 5.44-3380.0 mg/L; 37 above an AESTHETIC secondary standard only (secondary standard 250.0 mg/L (aesthetic)) - not a health finding