If You Notice Cloudy Water, Scale, or Reduced Flow, What Should You Check First?
Start by examining your fixtures and pipes for visible scaling or cloudiness, which can indicate elevated minerals. Next, verify that no physical blockages or mechanical issues exist in pumps or pressure tanks, as these can mimic water quality problems. If the problem persists, arrange for a certified laboratory analysis of your well water, specifying total dissolved solids (TDS) among the tested parameters to understand water quality accurately.
If Left Unchecked, What Could Happen Over Time?
Over years, untreated mineral-rich water can gradually cause build-up inside pipes and reduce equipment efficiency. This accumulation can lead to increased maintenance needs for water-using appliances and potential decreases in their lifespan. However, no immediate health hazards are implied by elevated TDS levels in this context, based on regional data from Kankakee County.
If You Notice Some Fixtures Are More Affected, Which Ones and Why?
Fixtures and appliances that heat water—such as water heaters and dishwashers—are often impacted first by dissolved solids, as heating encourages mineral precipitation. Faucets and showerheads may show scaling or reduced flow due to clogging from these deposits. Cold water taps may display fewer symptoms since temperature influences mineral solubility.
If You Want to Understand How TDS Enters Groundwater Here, What Should You Know?
US Geological Survey sampling in Kankakee County’s aquifer 110QRNR reveals total dissolved solids ranging from 0.05 to 466.0 milligrams per liter, with a median of 134.0 mg/L over samples collected between 2011 and 2021. These dissolved solids originate from natural geological formations dissolving into groundwater near the surface, at well depths between 12 and 23 feet. No federal thresholds for health safety were exceeded in these measurements, indicating typical regional mineral content rather than contamination.
If You Receive a Laboratory Report for Your Well, How Should You Read TDS Levels?
A certified lab report will list TDS as milligrams per liter (mg/L) or parts per million (ppm), describing the concentration of dissolved substances such as minerals. While elevated TDS can affect taste and promote scaling, it does not by itself indicate health risks. Comparing your report’s TDS figure with the regional range can help you understand if your water is typical or unusually mineralized for Kankakee County aquifer 110QRNR.
If You Experience Household Symptoms, Which Indicate High Dissolved Solids and Which Do Not?
Signs that can point to higher dissolved solids include mineral deposits on fixtures, cloudy water, or reduced appliance efficiency due to scaling. However, clear water with no taste or odor changes and no scaling tends to indicate TDS is likely within normal regional levels. Symptoms such as discoloration, unpleasant odors, or tastes may stem from other causes and warrant separate investigation.
Addressing these challenges, the Fleck Complete Well System ships ready to configure and offers 32,000 grain capacity to treat dissolved solids effectively, helping restore water quality typical for Kankakee County households dependent on aquifer 110QRNR.
Where this information comes from
Source: USGS groundwater sampling. Sampled 2021-06-29. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.
On record: U.S. Geological Survey sampling of Total dissolved solids in the 110QRNR aquifer (Kankakee County): 41 results from 7 wells, median 134.0 mg/L, range 0.05-466.0 mg/L; none above any federal threshold
- ✓ 90-Day Money-BackNo restocking fees — return within 90 days.
- ✓ Manufacturer WarrantyGenuine Fleck · Pentair · VIQUA equipment.
- ✓ Free Expert SizingTalk to a specialist and buy the right system the first time.