Comparing Franklin County's Aquifer Data with Nearby Areas
The U.S. Geological Survey has collected groundwater data from Franklin County's aquifer 121RGLD, sampling seven wells between 2010 and 2023 at depths ranging from 16 to 72 feet. This data shows total dissolved solids (TDS) levels with a median value of 400.5 milligrams per liter, spanning a wide range from 0.4 to 843.0 mg/L. While these figures represent regional conditions rather than any single household well, they help provide a context for understanding what might be typical or variable in this part of Washington.
When looking at neighboring counties, note that TDS levels may differ due to changes in geology, land use, and water source depths. However, data from Franklin County’s aquifer offers a useful baseline and should not be mistaken for a definitive measure of your own well’s content.
How the Autotrol Complete Well System Treats Total Dissolved Solids
The Autotrol Complete Well System addresses elevated TDS by employing a process designed to reduce dissolved mineral content that can impact taste, water clarity, and potential staining. While it does not alter every constituent, its configuration is optimized for removing substances responsible for aesthetic issues linked to higher TDS concentrations. The system ships ready to configure for household use and has a grain capacity of 32,000, balancing treatment capacity with typical residential water demand.
Understanding Detected, Median, and Range in Water Sampling
In the Franklin County aquifer data, 'detected' means the instrument measured total dissolved solids in all 48 samples, with none falling below reporting limits. 'Median' indicates the middle value of all measurements, here 400.5 mg/L, showing a central tendency of TDS levels. The 'range' extends from 0.4 up to 843.0 mg/L, reflecting the highest and lowest concentrations observed. It's important to see these numbers as part of a broader regional picture rather than a prediction of any single well’s water chemistry.
Fixtures and Appliances Most Affected by Elevated TDS
Household fixtures and appliances that use water directly, such as faucets, dishwashers, and water heaters, may experience effects from TDS levels above secondary standards. These effects often relate to taste, mild staining, or mineral deposits rather than health risks. The Autotrol Complete Well System targets treatment to improve water aesthetics by reducing minerals that contribute to these issues, helping protect plumbing components and extend appliance longevity.
Essential Notes Before Seeking Treatment Advice
When evaluating your well water, it’s critical to conduct specific testing on your own source to confirm its individual characteristics. Documenting water hardness, TDS levels, pH, and other relevant parameters will guide appropriate treatment choices. Comparing regional data can inform expectations but cannot substitute for this personalized information.
Prepare a detailed summary of your household water use, fixture types, and any known water quality concerns before consulting about treatment. This preparation supports precise recommendations tailored to your situation.
Summary of Regional Water Quality Data Scope
The data referenced here covers seven sampled wells within Franklin County’s aquifer 121RGLD between July 2010 and September 2023. It provides an overview of total dissolved solids found across these locations, representing regional groundwater conditions rather than any individual well. For more detailed information, the U.S. Geological Survey site remains the authoritative source.
Where this information comes from
Source: USGS groundwater sampling. Sampled 2023-09-26. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.
On record: U.S. Geological Survey sampling of Total dissolved solids in the 121RGLD aquifer (Franklin County): 48 results from 7 wells, median 400.5 mg/L, range 0.4-843.0 mg/L; 19 above an AESTHETIC secondary standard only (secondary standard 500.0 mg/L (aesthetic)) - not a health finding