Is complete well water treatment necessary for your Charleston County household? Government sampling from the USGS shows total dissolved solids (TDS) in the local aquifer vary widely. Evaluating this data can help guide your choice of water treatment.
How does the Fleck Complete Well System address total dissolved solids?
The Fleck Complete Well System uses advanced filtration technology designed to reduce elevated levels of total dissolved solids, which consist of minerals and salts dissolved in water. While TDS itself is not a health hazard, high levels can cause unpleasant taste, staining, and potential wear on plumbing fixtures. This system offers a 32,000-grain capacity treatment solution that can significantly improve water aesthetics and household water performance when configured properly.
What do 'detected', 'median', and 'range' mean in the USGS sampling data for Charleston County?
The USGS sampled two wells in Charleston County's 120FLRD aquifer across nine tests from 2011 to 2018. TDS was detected in every sample, with values ranging from 0.88 mg/L to 5720 mg/L and a median result of 646 mg/L. 'Detected' indicates the constituent appeared in measurements, not that it exceeds any safety standard. The 'range' shows the lowest and highest measured values across samples, reflecting natural variability at different depths and locations within the aquifer. The 'median' is the middle value when all are ordered, giving a typical concentration observed in the area.
How should Charleston County's TDS record be compared with neighboring counties?
Comparisons with adjacent counties should focus on relative TDS levels and trends without assuming uniform conditions across wells. Each aquifer and well depth contribute to water quality differences, so while Charleston County's median TDS is 646 mg/L, neighboring areas may have higher or lower medians due to distinct geological formations. Avoid interpreting area-wide data as representative of any single well, and do not conclude safety or safety issues on this basis alone.
What changes occur in tap water after applying the Fleck Complete Well System?
With the Fleck Complete Well System in place, many households notice improved taste and reduced staining caused by minerals dissolved in water. The system captures and removes a broad spectrum of dissolved solids, resulting in clearer water and less buildup on fixtures. This treatment enhances water quality aesthetics but does not alter water quantity or basic plumbing function.
What is the recommended order for evaluating your complete well water problem?
- Start with a visual and sensory inspection of your water for staining, taste, or odor concerns.
- Check household plumbing materials and maintenance history to identify unrelated causes of water issues.
- Obtain a certified laboratory water test from your specific well to measure TDS and other constituents directly.
- Review local USGS and public water system records for broader context but rely on your well test for decisions.
What additional questions might commercial or industrial operators consider?
Unlike a household, commercial or industrial users often assess flow rates, treatment capacity demands, and regulatory compliance beyond typical residential concerns. They may require testing for specific minerals affecting equipment longevity and process quality. For residential users, these commercial factors generally do not apply.
Ultimately, the single test to order is a comprehensive laboratory analysis of your well water, including total dissolved solids measurement. A result showing elevated TDS relative to household taste or staining tolerance would indicate that a treatment system like the Fleck Complete Well System could improve your water quality effectively.
Where this information comes from
Source: USGS groundwater sampling. Sampled 2018-08-16. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.
On record: U.S. Geological Survey sampling of Total dissolved solids in the 120FLRD aquifer (Charleston County): 9 results from 2 wells, median 646.0 mg/L, range 0.88-5720.0 mg/L; 6 above an AESTHETIC secondary standard only (secondary standard 500.0 mg/L (aesthetic)) - not a health finding