Fleck Acidic / Low-pH Water Filter

Buy Now

View full details

If You Consider the Number of Samples and Wells Behind the pH Figures

Government data for Douglas County’s aquifer comes from four water pH measurements taken from one well between 2014 and 2024. A single well’s readings provide a limited look at the subsurface water conditions over time but cannot fully represent the broad area or the variety of well depths and locations within the county. For a household experiencing failed equipment that targeted acidic water, this sample size means regional trends can be observed but individual water chemistry may differ. You should consider testing your own water to learn its exact pH value.

If You Wonder What Terms Like ‘Detected,’ ‘Median,’ and ‘Range’ Mean in This Sampling Record

All four samples detected pH values at Douglas County aquifer wells. The median pH was 7.45 standard units, with results ranging from 6.9 to 8.4. Detected means the equipment measured pH confidently; it does not imply a problem. The median is the middle value in the dataset, showing typical conditions, while the range shows the lowest and highest pH found. pH measures acidity or alkalinity on a scale where lower than 7 is acidic and higher is alkaline. Here, none of the readings fell below the EPA’s aesthetic secondary standard minimum of 6.5, indicating no evidence of acidic water at a level that typically causes taste or corrosion concerns in the sampled well.

If You Consider How Sample Depth and Well Type Affect What You Should Expect About Your Own Water

The sampled well was 120 feet deep, representative of many residential wells but not all. Deeper or shallower wells might encounter water with differing pH values due to geological layers and chemical interactions underground. Aquifer sampling reflects the general groundwater condition but cannot predict localized water quality in individual household wells. Obtaining a water test specific to your household well water is necessary to determine its current pH status and to confirm if acidic water is present.

If You Consider How Public System Records Differ from Private Well Testing in What They Establish

Public water system records document routine tests designed to meet regulatory requirements and provide general water quality information for wide service areas. Private well owners must perform their own water testing to identify specific water chemistry issues in their water. The aquifer pH data provides context but does not substitute for direct testing of your household water. Households facing equipment failure targeting acidic water should use their own water analysis to guide treatment choices.

If You Account for Differences for Large Households, Second Homes, or Seasonal Properties

Water treatment needs can vary with household size, frequency of water use, and property occupancy patterns. A large household or one with higher water demand may require treatment equipment designed for greater capacity or flow rates. Conversely, seasonal properties with intermittent water use may face different maintenance or operational considerations. Knowing your water’s pH through testing is critical to selecting an appropriate solution that matches your household’s unique usage and conditions.

If You Understand How EPA Secondary Standards Differ from Health-Based Limits, and How This Applies to pH

The EPA secondary standard for pH ranges between 6.5 and 8.5. This standard addresses taste, staining potential, and corrosivity but is not a health-based limit. None of the Douglas County aquifer samples fell below 6.5, indicating no aesthetic or corrosivity issues were detected in those samples. If your water is acidic—below the secondary standard threshold—equipment designed to adjust pH can restore water balance and reduce potential impacts like pipe corrosion or metallic taste. The Fleck Acidic / Low-pH Water Filter system ships ready to configure and is documented to address low-pH water effectively without requiring professional setup.

In summary, the Douglas County aquifer pH data comes from a small set of measurements drawn from one specific well at 120 feet depth, sampled over a ten-year span. It offers a regional snapshot but cannot replace testing your household water to understand its true pH condition. For residents dealing with equipment failure from acidic water, testing and appropriate treatment choices are essential. For full data details, please refer to the U.S. Geological Survey groundwater sampling records.

Where this information comes from

Source: USGS groundwater sampling. Sampled 2024-08-14. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.

On record: U.S. Geological Survey sampling of pH in the aquifer (Douglas County): 4 results from 1 wells, median 7.45 standard units, range 6.9-8.4 standard units; EPA secondary standard for pH is 6.5-8.5 (aesthetic/corrosivity, not health-based); 0 of 4 sampled results fell below 6.5