Groundwater pH Sampling in Beltrami County Aquifer 112DMDF
Sample Size and Well Depth
Three pH measurements were taken from two separate wells in Beltrami County’s aquifer 112DMDF over a period from August 2011 to June 2013. These wells were relatively shallow, 12 to 13 feet deep. The limited number of samples means the dataset provides an overview of local groundwater conditions but does not define individual household water characteristics.
Range of pH Values Observed
The recorded pH values ranged from 7.3 to 8.1 standard units, with a median value of 8.0. All results remained within the United States Environmental Protection Agency’s secondary standard range of 6.5 to 8.5 standard units, which is a guideline related to aesthetic qualities and corrosion potential rather than health risks.
Information to Record Before Seeking Treatment Guidance
Personal Water Testing Results
It is important to obtain a current water quality report specific to your household well or municipal supply to understand your water's pH. Relying solely on regional data will not clarify your home's water treatment needs.
Existing Equipment and Its Performance
Note the type of water treatment equipment currently in use, including its capabilities and any limitations you have observed regarding pH adjustment or corrosion control.
Household Plumbing Details
Document the age and materials of your plumbing, as these factors can influence water chemistry interactions and the effectiveness of treatment solutions.
Clarifying Acidic Water Versus Other Water Quality Issues
Not Confusing Low pH With Hard Water or Iron Presence
Acidic water is characterized by a lower pH value and potential corrosiveness, differing fundamentally from issues caused by water hardness or iron content, which typically affect scaling and staining.
Differentiation From Alkaline Water Conditions
Water with a pH above 7 is considered alkaline and behaves differently in plumbing and treatment contexts compared to acidic water.
The Influence of Plumbing Materials and Age
Possible Effects on Water Chemistry
Older plumbing materials might interact with water chemistry, either exacerbating or mitigating acidic conditions, independent of source water pH.
Importance of Materials Compatibility
Some materials are more resistant to corrosion associated with low-pH water, potentially affecting maintenance needs and water quality outcomes.
Steps to Rule Out Common Acidic Water Causes
Start with Visual and Taste Observations
Check for signs such as metallic taste or blue-green staining on plumbing fixtures, which may indicate low pH effects.
Follow With Basic Home Testing Kits
Consider using simple pH testing kits to monitor household water before opting for more complex analyses.
Laboratory Analysis for Detailed Profile
When necessary, laboratory testing can provide comprehensive information on water chemistry, including pH and related parameters.
Considering the C-Series Acidic / Low-pH Water Filter
Technology Designed for Acidic Water Conditions
The C-Series Acidic / Low-pH Water Filter ships ready to configure as a response to persistent acidic water conditions that existing systems cannot fully address.
Key Functions of the Equipment
This system is designed to adjust water pH toward a neutral range, helping to reduce corrosion potential and improve water aesthetics and compatibility with household plumbing.
Conclusion and Government Water Quality Data Reference
The pH sampling record for wells in Beltrami County’s aquifer 112DMDF provides a regional overview reflecting pH values between 7.3 and 8.1 measured in a small set of shallow wells. For detailed, household-specific water quality information, testing of your own water source is necessary. The U.S. Geological Survey groundwater sampling data used here is available at the official source for further consultation.
Where this information comes from
Source: USGS groundwater sampling. Sampled 2013-06-03. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.
On record: U.S. Geological Survey sampling of pH in the 112DMDF aquifer (Beltrami County): 3 results from 2 wells, median 8.0 standard units, range 7.3-8.1 standard units; EPA secondary standard for pH is 6.5-8.5 (aesthetic/corrosivity, not health-based); 0 of 3 sampled results fell below 6.5