Fleck Acidic Water + Hard Water (Well) System

Buy Now

View full details

Understanding Martin County Groundwater Conditions

In Martin County, Florida, groundwater drawn from aquifer 112NRSD has been studied by the U.S. Geological Survey through samples taken from wells between 125 and 125 feet deep. These samples, collected over the course of nearly a year ending in September 2020, show pH values ranging from 6.9 to 7.8 with a median of 6.9 standard units. This data does not represent any single well but provides an overview of conditions in this area of the aquifer.

The pH scale measures how acidic or basic water is, with lower values indicating acidity. Water at a pH below 6.5 is considered acidic and potentially corrosive according to EPA secondary standards, which address aesthetics and plumbing impact rather than health. In this area, none of the sampled results fell below 6.5, suggesting that highly acidic water is not commonly detected in these samples.

How pH and Hardness Affect Household Water

Even within this pH range, water that trends toward the lower end can interact with household plumbing and appliances in ways that cause corrosion, staining, or metal leaching. Hardness, which is caused by dissolved minerals such as calcium and magnesium, can complicate these effects by causing scale buildup and reducing the performance of soaps and detergents.

When both acidity and hardness are present, water treatment must address these issues simultaneously to protect plumbing and improve water quality. Simply addressing hardness may not prevent corrosion caused by acidic water, and neutralizing acidity without controlling hardness may leave scaling problems unaddressed.

Testing Your Water for Informed Decision Making

Because regional data only describes general aquifer conditions, homeowners should conduct specific water tests to determine actual pH and hardness levels in their water supply. A comprehensive test will measure pH across its full range and quantify hardness-causing minerals. These results help identify whether low pH, hardness, or both require treatment.

Technology to Manage Both Acid and Hardness

When treatment for acidic and hard water is needed, equipment that includes a neutralizing component can adjust pH levels upward, reducing corrosivity. Additionally, components designed to soften water minerals help prevent scale buildup. A product like the C-Series Acidic / Low-pH Water Filter uses neutralizer technology to balance acidity while addressing hardness concerns.

This system ships ready to configure with your household plumbing setup, allowing integration without specialized trades. It helps homeowners control the factors that affect their water's taste, appearance, and impact on fixtures and appliances.

Making Your Treatment Choice

Start by testing your household water thoroughly for both pH and hardness. Compare your results with regional water quality data to understand your water’s behavior. If low pH and hardness are present at levels that affect your home, consider neutralizing and softening solutions like the C-Series filter. This approach targets both aspects effectively, reducing corrosion risk and scaling.

Remember, detection of acidic or hard water characteristics in the region does not guarantee the same conditions in your home, so personalized testing is essential for an informed, effective treatment decision.

Where this information comes from

Source: USGS groundwater sampling. Sampled 2020-09-17. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.

On record: U.S. Geological Survey sampling of pH in the 112NRSD aquifer (Martin County): 3 results from 1 wells, median 6.9 standard units, range 6.9-7.8 standard units; EPA secondary standard for pH is 6.5-8.5 (aesthetic/corrosivity, not health-based); 0 of 3 sampled results fell below 6.5

The documented solution

C-Series Acidic / Low-pH Water Filter