Fleck Acidic Water + Hard Water (Well) System

Buy Now

View full details

Understanding Public-Area Water Data vs. Private Well Testing

Public data reflects multiple wells, not individual household water

Measurements for Lee County's aquifer 230SDMR are based on 56 samples from 53 wells sampled over a few months in 2012. This sampling provides a regional profile, not a direct reading of any one household's water quality.

Acidity range found in area wells

The median pH measured was 6.7 standard units, with values ranging from 4.3 to 8.6. Twenty of the 56 samples recorded pH below the EPA’s secondary standard threshold of 6.5, indicating some naturally acidic water presence in the region.

Hardness level evidence must come from a specific well test

The publicly available data does not specify hardness concentrations for this aquifer; a certified test of your own water is needed to confirm hardness levels relevant to your household needs.

How the Fleck System Addresses Acid and Hardness

Neutralizing low pH to reduce acidity effects

The Fleck Acidic Water + Hard Water System uses specific media and controlled treatment cycles to increase pH toward neutral, mitigating issues associated with acidic water in household plumbing and appliances.

Effective removal of hardness minerals

This system provides a grain capacity of 32,000, suitable for softening typical hardness ranges found in private well water, helping prevent scale buildup from calcium and magnesium.

Seasonal and Long-Term Variations Documented in Sampling

Sampling period detail

The data represents measurements from April to August 2012, covering late spring through summer months.

Depth of sampled wells

Wells sampled ranged from 60 to 370 feet deep. Water chemistry can vary with depth and season, so individual household water may differ.

Sample Size and Interpretation Limits

Sample number and significance

Fifty-six results represent a moderate sample size for regional aquifer assessment but may not capture all local variations in water chemistry within Lee County.

Range of pH values shows diversity

The wide pH range of 4.3 to 8.6 highlights that acidic and neutral to slightly alkaline conditions can both occur locally.

How Certified Laboratory Tests Report pH and Hardness

pH reported as standard units on a scale

Laboratories report pH values to indicate water's acidity or alkalinity; values below 6.5 suggest acidic water per EPA secondary standards, relevant for aesthetic and material effects.

Hardness reported as mg/L calcium carbonate or grains per gallon

Hardness testing quantifies dissolved calcium and magnesium minerals; this figure helps determine the capacity and appropriateness of water softening equipment for your household.

Maintenance Rhythm of the Fleck Acidic Water + Hard Water System

Regular media regeneration cycles

The system performs programmed regeneration based on water usage to maintain softening and pH neutralization effectiveness without your needing additional adjustments.

Periodic media replacement

Over time, treatment media capacity approaches 32,000 grains; media replacement intervals depend on household water demand and local water quality.

For households in Lee County evaluating equipment options, the Fleck Acidic Water + Hard Water System ships ready to configure, providing capacity suited to typical residential demands while addressing both acidity and hardness based on regional water data and individual water testing.

Where this information comes from

Source: USGS groundwater sampling. Sampled 2012-08-09. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.

On record: U.S. Geological Survey sampling of pH in the 230SDMR aquifer (Lee County): 56 results from 53 wells, median 6.7 standard units, range 4.3-8.6 standard units; EPA secondary standard for pH is 6.5-8.5 (aesthetic/corrosivity, not health-based); 20 of 56 sampled results fell below 6.5