Interpreting Detected Measurements, Median Values, and Range in Camden County Water Data
The U.S. Geological Survey collected groundwater samples from three wells in Camden County within aquifer 110QRNR, recording 31 measurements of hardness based on calcium and magnesium concentrations between July 2015 and April 2017. Detection means the instruments measured presence, while median and range provide a summary of central tendency and variability across samples. The median hardness was 9.96 mg/L, with a range from 7.44 to 22.2 mg/L. No values exceeded any federal thresholds, indicating these hardness levels fall within regulatory parameters but still may affect household water properties.
Appliances and Fixtures Most Vulnerable to Acidic and Hard Water Conditions
Household components exposed to water with acid and hardness levels typical of Camden County's aquifer 110QRNR include water heaters, faucets, and washing machines. Acidic water can gradually wear plumbing materials, while hardness—due to calcium and magnesium—can cause scale buildup reducing appliance efficiency and longevity. These effects typically manifest first in fixtures with frequent water contact and heating elements where mineral deposits accumulate faster.
Water Characteristics at the Tap Following Treatment With the Fleck System
The Fleck Acidic Water + Hard Water (Well) System ships ready to configure to effectively address combined acid and hardness issues documented in this area. It reduces hardness by removing calcium and magnesium ions and balances pH to mitigate acidity. This treatment results in water that is gentler on plumbing and appliances, improves taste, and reduces scale deposits, enhancing household water quality after existing equipment failures.
Comparing Camden County’s Water Record to Neighboring Areas Without Overreading Sample Data
When reviewing water quality records from adjacent counties, it is important to note differences in aquifer geology or sampling periods that affect acid and hardness levels. Area-specific median and range values reflect localized conditions rather than a universal standard. Therefore, comparisons should guide expectations without assuming the same concentrations apply to every well or household in either county.
Distinctions Between Public Water System Records and Private Well Testing
Public water system reports document compliance with health-based standards across serviced areas but may not capture the full variability experienced by individual private wells drawing from aquifer 110QRNR. Private well owners must perform independent water tests to precisely determine their water chemistry, particularly for acid and hardness levels, since area-wide samples only provide contextual insight rather than individual well data.
Sample Size, Number of Wells Tested, and Implications for Data Confidence
The 31 hardness measurements come from three wells sampled over nearly two years. This sample size provides a reasonable overview of aquifer 110QRNR’s typical hardness range but remains limited in capturing all local variations. Homeowners should consider individual testing to capture their specific water characteristics, as small sample sets may not reflect all possible conditions within Camden County.
In summary, the data presented covers groundwater sampling from three wells in Camden County’s aquifer 110QRNR, with hardness detected in all 31 results and no federal thresholds exceeded. This record helps understand regional water quality but cannot substitute for precise testing of an individual home’s water. For further details, see the U.S. Geological Survey groundwater data source.
Where this information comes from
Source: USGS groundwater sampling. Sampled 2017-04-01. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.
On record: U.S. Geological Survey sampling of Hardness, Ca, Mg in the 110QRNR aquifer (Camden County): 31 results from 3 wells, median 9.96 mg/L, range 7.44-22.2 mg/L; none above any federal threshold