Fleck Radon in Water Filter

Buy Now

View full details

Large Households, Second Homes, or Seasonal Properties Have Different Water Use Patterns

Lycoming County’s aquifer 344HMLN has shown radon-222 concentrations ranging from 6.0 to 11.0 pCi/L in government sampling of three wells between 220 and 500 feet deep. This median range applies to the area, not individual wells. Households with more occupants or higher water use rates may draw more water daily, affecting how often radon in water enters the home’s air through water use activities. Second homes or seasonal properties might experience different exposure patterns due to irregular usage. Understanding your household’s water consumption helps evaluate potential radon impacts alongside area data.

Start With Simple Checks Before Laboratory Testing

The regional data reflects radon detection but does not establish your water’s radon levels. Before considering specialized water testing, check for radon levels in indoor air, which is often the primary exposure route. If radon in air is low, radon from water may be less concerning. Should water testing be warranted, a certified laboratory analysis of your specific water source provides the only definitive result. Relying on area aquifer data alone cannot determine individual household radon concentration.

Commercial or Industrial Water Users Should Ask Additional Questions

While residential water use involves smaller volumes, commercial or industrial operators might process large quantities or use water for sensitive applications. They should assess radon concentrations relevant to their processes and regulatory frameworks. Questions about water source variability, treatment capacity, and potential radon release during operations become critical. Residential guidelines, including the government sampling data referenced here, do not substitute for operational risk assessments or compliance evaluations in commercial settings.

Maintenance Requirements for the Fleck Radon in Water Filter

The Fleck Radon in Water Filter system ships ready to configure for your household water treatment needs. Routine maintenance involves periodic system checks and media replacement per the product guidelines to maintain treatment effectiveness against radon. Regular monitoring of water radon levels supports timely maintenance actions. Fleck’s approach addresses radon by reducing its presence in water before use, thereby lowering airborne radon release during household water activities.

Well and Source Depth Influence Expectation of Radon Levels

The three USGS wells sampled at depths from 220 to 500 feet reflect deep groundwater radon levels typical of Lycoming County’s aquifer 344HMLN. Shallower wells or surface water sources may present different radon behavior due to geological variations. Because radon is a naturally occurring gas that dissolves from underground rock, well depth and aquifer characteristics directly impact water radon concentration. Homeowners with shallower wells should consider that their radon levels could differ from the regional median.

Fixtures and Appliances Impacted First by Radon in Water

Radon released from water enters the home air primarily during water use activities that agitate water, such as showering, cooking, and washing dishes or clothes. Plumbing fixtures like showers, faucets, and appliances using water indoors are initial points where radon transfers to indoor air. Treatment systems like the Fleck Radon in Water Filter reduce radon before it reaches these fixtures, lowering the potential for airborne exposure within the household environment.

What You Should Not Conclude from Regional Radon Data

Area-wide sampling for Lycoming County’s aquifer 344HMLN shows radon-222 levels consistently below any federal threshold. However, this regional data is not a substitute for testing your own water source to know its radon concentration. Detection of radon in wells sampled does not imply a violation or an unsafe condition. The government figures cannot predict the exact water quality of your household supply. To make informed decisions about radon risk and treatment, you need a water test specific to your well or water source.

Where this information comes from

Source: USGS groundwater sampling. Sampled 2014-08-26. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.

On record: U.S. Geological Survey sampling of Radon-222 in the 344HMLN aquifer (Lycoming County): 3 results from 3 wells, median 8.0 pCi/L, range 6.0-11.0 pCi/L; none above any federal threshold