Autotrol Orange Iron & Rust Stains Filter

Buy Now

View full details

Government Sampling Records Iron Presence in Kitsap County Aquifer Water

The U.S. Geological Survey collected 36 samples from 18 separate wells in the Kitsap County aquifer area between March and May 2021. Iron was detected in 23 of those results, with a median concentration of 0.216 mg/L and a wide range from non-detectable levels up to 2110 mg/L. These wells were relatively shallow, measuring between 16 and 27 feet in depth. This record reflects what is found across this area aquifer but does not represent any single household's water.

How the Autotrol System Removes Iron and Rust Staining Constituents

The Autotrol Orange Iron & Rust Stains Filter uses a specialized filtration technology designed to reduce iron particles that cause rust discoloration and staining in water. This system works by capturing iron compounds before they reach household taps, improving water clarity and minimizing rust-related issues on plumbing fixtures and laundry. It is prepared to ship ready to configure, without additional setup complexity.

What the Measured Iron Range Means Within Federal Guidelines and Aesthetic Thresholds

Among the 36 area samples, only 5 exceeded the secondary aesthetic standard of 0.3 mg/L for iron. This secondary standard is concerned with taste and staining potential rather than safety. A detection above or below this threshold does not indicate a safety violation or health risk. Instead, it signals a potential for water to exhibit rust-like discoloration or metallic taste, which many residents find undesirable. Therefore, these findings inform about aesthetic water quality concerns rather than regulatory compliance issues.

How Iron Problems Differ from Commonly Confused Water Issues

Rust and iron staining are often mistaken for other water quality problems but are distinct. Unlike sediment or hardness, iron presence manifests primarily as discoloration or staining, often reddish-orange, and metallic taste. It is not related to biological contaminants or water hardness minerals like calcium or magnesium. Understanding this difference helps in selecting the appropriate treatment technology targeted specifically at iron, such as the Autotrol System, rather than more general or unrelated filters.

How Water Quality Improves at the Tap with Iron and Rust Filtration

Once filtered through the documented system, water clarity improves noticeably. The typical rust-colored staining on fixtures and laundry diminishes, and metallic tastes lessen or disappear. This results in more visually appealing water and fixtures and reduces the need for frequent cleaning caused by iron deposits. While the filtered water may still contain trace iron amounts, the iron forms responsible for staining and rust are significantly reduced.

What the Number of Samples and Wells Indicates About Area Iron Levels

The data comes from 36 samples taken from 18 separate shallow wells within the aquifer area. This is a moderate sample size that offers a snapshot of the typical range of iron concentrations. However, variability is high as indicated by the broad range, so individual wells can have very different iron levels. Residents should therefore test their own water to determine exact conditions rather than assuming they match the area profile.

What This Data Does Not Establish

These regional iron data do not determine the iron content or safety of any one household's water supply. Iron presence at detected levels is not a health concern but an aesthetic one. Testing of a specific well or water source is necessary to choose the most effective treatment. This record should not be used to conclude that a home’s water has iron problems, nor that it lacks them, only that iron is known to be detected across the Kitsap County aquifer system in varying amounts.

Where this information comes from

Source: USGS groundwater sampling. Sampled 2021-05-26. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.

On record: U.S. Geological Survey sampling of Iron in the aquifer (Kitsap County): 36 results from 18 wells, median 0.216 mg/L, range 0.0-2110.0 mg/L; 5 above an AESTHETIC secondary standard only (secondary standard 0.3 mg/L (aesthetic)) - not a health finding