Comparing Santa Fe County Uranium Data with Neighboring Counties Without Overreading
The U.S. Geological Survey has gathered uranium concentration data from 10 wells sampled throughout Santa Fe County's aquifer S100RIOGRD area during mid-2014 to early 2015. These measurements provide a documented range and median of uranium levels in this aquifer but do not convey specific information about any individual well’s water. When comparing these figures to data from adjacent counties, remember that geological and hydrological conditions can vary significantly, meaning uranium concentrations in neighboring aquifers may be higher or lower. Using area-wide sampling as a general reference helps avoid assumptions about your own household water quality.
Effects of Sample Depth, Well Depth, and Source Type on Expected Uranium Levels
The sampled wells in Santa Fe County ranged from 80 to 800 feet deep, reflecting how uranium concentration can differ with depth. Deeper wells may intersect different rock formations or groundwater flows, affecting uranium presence. Because uranium naturally occurs in certain minerals, water sourced from these depths may carry different uranium levels compared to shallow wells or surface water sources. Knowing the depth and type of your source water is an important factor in anticipating uranium presence but does not substitute for direct testing.
What a Certified Laboratory Test Reports for Uranium and How to Interpret It
If you want to determine uranium levels in your household water, a certified laboratory test is necessary. Such a test reports precise uranium concentrations typically expressed in micrograms per liter or milligrams per kilogram. The lab result will include a detection level and may reference relevant federal guidelines. It is important to understand that detection alone is not a violation or a safety indication. Whether the uranium level found requires action depends on how it compares to federal health-based standards. The area data show no federal threshold exceedances, indicating the aquifer generally meets those standards.
Sample Size and Well Coverage Underpinning Santa Fe County's Uranium Figures
The 28 uranium results come from 10 separate wells sampled over roughly seven months. While covering a range of well depths, this limited sample size means these figures provide a snapshot—median 4.95 mg/kg and a range from 0.181 up to 37.0 mg/kg—rather than a comprehensive or continuous record. Small sample sizes in groundwater studies should be interpreted with caution, as local variability within the aquifer could occur. Still, these data form an evidence-based basis for understanding typical uranium conditions in the area.
Routine Care for the C-Series Uranium & Radium System in a Household Setting
The C-Series Uranium & Radium System ships ready to configure for residential water treatment. Its grain capacity of 32,000 supports long-term reduction of uranium and radium levels in household water supplies. Routine maintenance involves predictable rhythm checks for media exhaustion and system flushing to maintain effectiveness—details provided by the product documentation. This maintenance ensures the unit can consistently reduce constituents documented in the area without interruption.
What Test Should You Order Next?
To clarify your household’s uranium status, order a certified laboratory test specifically for uranium concentration in your water source. A result below federal health-based standards would settle concerns about uranium severity. If the test shows a level approaching those guidelines, considering the C-Series Uranium & Radium System as a treatment option may be appropriate. This targeted approach avoids assumptions based on area sampling and addresses your specific water condition with evidence.
Where this information comes from
Source: USGS groundwater sampling. Sampled 2015-01-13. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.
On record: U.S. Geological Survey sampling of Uranium in the S100RIOGRD aquifer (Santa Fe County): 28 results from 10 wells, median 4.95 mg/kg, range 0.181-37.0 mg/kg; none above any federal threshold