Fleck Uranium & Radium System

Buy Now

View full details

This week, you need to decide how to address uranium and radium detected in your household water after your existing equipment has ceased to perform effectively.

Symptoms in Your Home May Not Clearly Indicate Uranium-Radium Presence

It’s common to wonder if issues like unusual taste, staining, or equipment failure relate directly to uranium and radium in your water. However, these elements themselves do not cause noticeable taste or odor and do not create visible stains. Equipment failure can stem from many causes unrelated to uranium or radium levels. To confirm whether uranium or radium is an issue in your household water, testing of your water specifically is necessary, since symptoms alone cannot establish their presence or concentration.

Public Aquifer Data Provides a Regional Snapshot, Not Your Well’s Specific Condition

The U.S. Geological Survey’s sampling of wells in Lowndes County’s aquifer 211EUTW offers measurements from multiple wells between 116 and 296 feet deep. While these samples show alpha particle activity—which indicates uranium and radium presence—in every tested well, this data represents the area, not your individual water supply. The median value in these samples was 0.9 pCi/L, with a range from 0.6 to 1.9 pCi/L. None exceeded any federal threshold or health-based limit. Your water could be different; only a specific test of your well or household water can confirm the actual levels you face.

How Uranium and Radium Enter Groundwater in Lowndes County’s Aquifer 211EUTW

In this region, uranium and radium naturally occur in the underground rock formations that store groundwater. Over time, these elements dissolve into the water that moves through aquifer 211EUTW. The extent to which they appear in any particular well depends on factors like the depth of the well, the local geology, and groundwater flow patterns. Because these elements originate from natural sources, their presence is expected in the aquifer but varies from place to place.

Interpreting ’Detected’, ’Median’, and ’Range’ in the Area’s Uranium-Radium Record

The government sampling data labels uranium and radium levels as ’detected’ in all measured samples, meaning instruments measured alpha particle activity above the reporting limit. The ’median’ value of 0.9 pCi/L represents the middle value in the dataset, while the ’range’ from 0.6 to 1.9 pCi/L shows the lowest and highest measurements recorded among the tested wells. Importantly, no result exceeded federal limits or health-based thresholds. These terms describe the regional data but do not indicate whether your water contains higher or lower levels.

How Treated Water Changes at Your Tap with the Fleck Uranium & Radium System

When you use the Fleck Uranium & Radium System, which ships ready to configure for direct purchase, it addresses uranium and radium in your household water by reducing alpha particle activity to levels consistent with safe use. The system’s 32,000-grain capacity supports sustained performance. Treated water delivered at the tap will not have the alpha activity that the incoming water recorded in the area’s samples. Proper testing before and after treatment confirms effectiveness and ensures water quality meets your household’s needs.

Deciding how to respond to uranium and radium concerns starts with understanding what the regional data shows and does not show for your well. Testing your household water and considering a treatment solution like the Fleck Uranium & Radium System helps restore confidence after your previous equipment’s failure.

Where this information comes from

Source: USGS groundwater sampling. Sampled 2019-08-12. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.

On record: U.S. Geological Survey sampling of Alpha particle in the 211EUTW aquifer (Lowndes County): 6 results from 3 wells, median 0.9 pCi/L, range 0.6-1.9 pCi/L; none above any federal threshold