Fleck Rotten-Egg Sulfur Smell Filter

Buy Now

View full details

How Sulfide Enters Groundwater in Lee County's Aquifer 120UFAQ

When you notice a sulfur smell at your household faucet in Lee County, it often originates from sulfide compounds naturally present in groundwater. In this area, the deep aquifer known as 120UFAQ is a common water source for wells. Sulfide forms under low-oxygen conditions as organic material decomposes in sediments far below ground. It then dissolves into the water that eventually emerges from deep wells. This process is natural and not unique to any one household but characteristic of the regional geology and aquifer environment.

Understanding the Maintenance Rhythm of the Fleck Rotten-Egg Sulfur Smell Filter

The Fleck Rotten-Egg Sulfur Smell Filter is designed to address the sulfur odor by filtering out sulfide before water reaches your taps. It ships ready to configure for household water systems and typically requires maintenance involving periodic media replacement or regeneration based on water use and sulfide levels. While exact intervals vary, a general rhythm is to check filter performance annually or as odor returns, ensuring the filter continues reducing the sulfur smell effectively.

What 'Detected,' 'Median,' and 'Range' Mean in Lee County's Sulfide Sampling Record

The U.S. Geological Survey sampled sulfide in two wells from Lee County’s 120UFAQ aquifer, measuring concentrations between 1.4 and 2.2 mg/L with a median of 1.9 mg/L. All three samples detected sulfide; none were below the reporting limit. These figures represent regional data from wells approximately 775 to 883 feet deep and do not reflect individual well conditions. Detection here means instruments measured sulfide presence—it is not a health violation or an indicator of unsafe water. The median value shows the middle concentration level found, while the range encompasses the lowest to highest measured levels in these samples.

What to Record Before Seeking Treatment Advice

Before pursuing options for reducing sulfur smell, gather specific information about your household water. This includes results from a local laboratory test of your well or tap water for sulfide concentration, the depth of your well, and any other detected odors or changes over time. Note also any household water use patterns, such as frequency and volume, as these can influence treatment needs. Having your own water test distinguishes your situation from regional sampling and is critical to tailoring a successful solution.

Ruling Out Causes: From Simple Checks to Professional Testing

Begin by verifying if the sulfur smell comes from your water source or elsewhere. Flush taps thoroughly to see if odor dissipates, and check if the smell is present at both hot and cold water taps. Consider inspecting water heater tanks for bacterial growth, since sulfur bacteria can contribute to smells inside plumbing. If the problem persists, a laboratory test of your water for sulfide and other compounds is the next step. This test confirms the presence and concentration of sulfur compounds to justify a treatment system such as the Fleck Rotten-Egg Sulfur Smell Filter.

Differences Between Public-System Records and Private-Well Testing for Sulfur Smell

Public water system records in Lee County report no health-based violations related to sulfide, reflecting compliance with federal standards. These records encompass tested samples from municipal sources and do not address household-specific water conditions. Private wells access groundwater directly from aquifers like 120UFAQ, so testing individual well water is essential to identify sulfur compounds causing odor. Public data provide context but cannot replace personal water analysis for treatment decisions.

In summary, household sulfur smell in Lee County often reflects natural sulfide presence in deep aquifers rather than contamination. Government sampling shows consistent sulfide detection without health violations, emphasizing the need for individual water testing. The Fleck Rotten-Egg Sulfur Smell Filter offers a documented treatment option once local water conditions justify it, supporting clearer, better-tasting household water.

Where this information comes from

Source: USGS groundwater sampling. Sampled 2026-01-28. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.

On record: U.S. Geological Survey sampling of Sulfide in the 120UFAQ aquifer (Lee County): 3 results from 2 wells, median 1.9 mg/L, range 1.4-2.2 mg/L; none above any federal threshold