Pentair Radon in Water Filter

Buy Now

View full details

1. What the Measured Range Means Against Federal Standards, and What It Does Not Mean

The U.S. Geological Survey has sampled groundwater from three wells in Miller County’s 124SPRT aquifer between July and October 2012. Radon-222 was detected in all samples, with levels ranging from 49.0 to 370.0 picocuries per liter (pCi/L), and a median of 55.0 pCi/L. Notably, none of these samples exceeded any federal radon threshold. This data represents a range observed among wells 85 to 150 feet deep in the general area, not a specific reading from any single household’s water.

It is important to understand that detection does not equal a violation or a health hazard. The federal thresholds relate to health advisories, but the mere presence of radon at these levels indicates only that radon is naturally occurring in these groundwater sources. Individual well testing is required to ascertain the exact radon concentration in your household water.

2. Which Household Fixtures, Appliances, or Processes Are Affected First and Why

Radon dissolves in water and can be released into indoor air during water use, especially where water is aerated or heated. Fixtures such as showers, faucets, and appliances that use water for heating or spraying release radon gas into home air. Showers are often the first point where radon may be noticed because the water agitation releases gas into the bathroom. Faucets and humidifiers also contribute but typically at lower rates. Understanding these points helps prioritize treatment efforts based on household water use.

3. What You Should Write Down Before Asking for Treatment Advice

Before seeking personalized treatment solutions, it helps to collect the following information:

• Results from a certified radon water test of your household well or supply.
• Depth and construction details of your well.
• Typical water usage patterns, especially fixtures where water agitation or heating is significant.
• Age and material of your home’s plumbing system.

Having this data ready enables more precise advice tailored to your home's specific conditions and radon levels.

4. The Role of Plumbing Material and Age, Separate from Source Water

While radon originates from the groundwater, the materials and age of your plumbing system do not directly increase or decrease radon levels. However, older plumbing systems with leaks or corrosion may affect water quality in other ways, possibly influencing the effectiveness of radon removal treatments. Understanding your plumbing is important for choosing the right system configuration but does not alter radon presence.

5. What 'Detected,' 'Median,' and 'Range' Mean in the Sampling Record on This Page

In the USGS record, 'detected' means radon was measured above the instrument’s reporting limit in all sampled wells but does not imply any violation or unsafe condition. The 'median' (55.0 pCi/L) is the middle value of the three results, providing a central tendency measure of radon concentrations sampled. The 'range' (49.0 to 370.0 pCi/L) expresses the spread between lowest and highest measurements, reflecting variability among sampled wells in the area. These figures describe groundwater conditions for Miller County’s 124SPRT aquifer only, not an individual home’s water.

Based on this information, systems like the Pentair Radon in Water Filter offer a direct-purchase option designed to reduce radon levels in household water. It ships ready to configure for your setup, providing a documented method to address radon where treatment is desired.

In summary, the USGS sampling for Miller County’s 124SPRT aquifer found radon present in all sampled wells with no federal threshold exceedances. This record covers three wells sampled in mid-2012 at depths of 85 to 150 feet. To understand your household’s specific radon levels, conduct a certified water test. See https://waterdata.usgs.gov/monitoring-location/331604093510901/ for full government data.

Where this information comes from

Source: USGS groundwater sampling. Sampled 2012-10-29. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.

On record: U.S. Geological Survey sampling of Radon-222 in the 124SPRT aquifer (Miller County): 3 results from 3 wells, median 55.0 pCi/L, range 49.0-370.0 pCi/L; none above any federal threshold