The groundwater supporting homes in Creek County, Oklahoma, draws from the aquifer known as 110ALVM. This aquifer feeds many local wells ranging in depth roughly from 7 to 50 feet. Water from the aquifer goes through a natural underground journey before arriving at residential taps, delivering essential hydration and utility functions. Knowledge about the aquifer's water quality gives a helpful starting point but does not define an individual household’s water condition.
Understanding 'Detected,' 'Median,' and 'Range' in Creek County Sampling
The U.S. Geological Survey collected 38 nitrite test results from 19 wells in Creek County’s 110ALVM aquifer during late 2022. Of these, nitrite was detected in 16 results but remained below the smallest reliably reported amount in 22 others. The median—meaning the middle value when all results are ordered—was 0.005 milligrams per liter, with a full range from 0.001 to 0.025 mg/L. These terms describe the distribution and frequency of measured nitrite but do not indicate the nitrate levels in your well specifically. They reflect what was found in sampled wells across the area only.
Seasonal and Multi-Year Variation in Nitrate and Nitrite Levels
The samples were collected over a short period, from October 10 through November 3, 2022. Because data cover less than a full year, they do not capture how nitrate or nitrite concentrations might fluctuate with seasons or across multiple years. Aquifer chemistry can vary due to rainfall, land use changes, or groundwater flow patterns, but this particular record offers a snapshot, not a full temporal profile.
Estimating Treatment Capacity Compared to Household Water Demand
When considering treatment for nitrate or nitrite, it is important to compare the potential capacity of any solution against your household’s daily water use. The C-Series Nitrate & Nitrite (Well) Filter ships ready to configure for typical home water flows. Knowing your average daily consumption helps ensure any filter system can handle the volume without bottlenecks or excessive maintenance needs.
Testing Steps: From Cost-Effective Checks to Definitive Laboratory Analysis
Begin by reviewing your well's condition and any recent water reports for context. Simple screening tests can check for common ancillary factors, but only a certified laboratory can measure nitrate and nitrite concentrations precisely. Because regional data do not specify your well’s status, a dedicated test provides the factual basis to decide on any treatment method confidently.
What Do the Measured Ranges Indicate Against Federal Standards?
Federal standards set maximum contaminant levels for nitrate and nitrite to protect health. In Creek County’s sampled wells, no recorded nitrite value exceeded any federal threshold. This means the government data for the aquifer show levels below the limits considered a health concern. However, detection alone is not a violation, nor does a value below the limit rule out localized issues. Your water might differ substantially from the regional median and range.
Comparing Creek County Nitrate Records with Neighboring Areas
While Creek County’s nitrate and nitrite findings can be contrasted with those from nearby counties, such comparisons must be cautious. Different geology, agricultural practices, or well depths may cause variations. The presence or absence of detections in one county does not predict the same for another. Regional comparisons can highlight trends but should not substitute for an individual water test.
To confidently determine your household water’s nitrate and nitrite levels, arrange for a well water test focused on these contaminants. A test result that falls within recommended limits provides peace of mind, while higher levels can guide treatment decisions. The C-Series Nitrate & Nitrite (Well) Filter offers a documented option to address nitrate and nitrite when necessary but should be considered after understanding your specific water chemistry confirmed by testing.
Where this information comes from
Source: USGS groundwater sampling. Sampled 2022-11-03. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.
On record: U.S. Geological Survey sampling of Nitrite in the 110ALVM aquifer (Creek County): 38 results from 19 wells, median 0.005 mg/L, range 0.001-0.025 mg/L; none above any federal threshold