Autotrol Black Manganese Stains Filter

Buy Now

View full details

Seasonal and Multi-Year Variation in Manganese Data

Sampling Dates Span 2011 to 2017

Multiple groundwater wells in this CT area, drawing from aquifer 112DFSF, were sampled between September 2011 and September 2017. These samples represent different times over nearly six years, indicating manganese presence across seasons and years.

Range of Manganese Detected in Area Wells

Of five measurements from four wells 32 to 75 feet deep, manganese was detected in three, ranging from 0.29 to 2.47 micrograms per liter (µg/L). Two samples fell below the laboratory reporting limit.

Interpreting Manganese Levels Against Federal Standards

All Samples Below Federal Health Thresholds

None of the manganese results from these wells exceeded any federal health-based standard. This does not mean manganese is absent, but the concentrations observed are within ranges deemed acceptable by federal guidelines.

Detection vs. Exceedance Clarification

Detection indicates measurement of manganese presence but is not a legal or health violation. Values below reporting limits are not quantifiable and do not imply safety or risk without further testing.

Understanding the Data as a Homeowner

Median Value Reflects Typical Local Concentration

The median manganese concentration recorded was 1.85 µg/L, suggesting that half the sampled values were above and half below this point. Homeowners should consider their own water testing since local area data cannot pinpoint individual well conditions.

Range Highlights Variability Across Wells

The spread from 0.29 to 2.47 µg/L shows manganese levels vary between wells in this aquifer. Individual home water can differ depending on depth, well location, and other site-specific factors.

Special Considerations for Different Household Types

Large Households May Have Greater Water Usage Impact

Families with higher water demand might notice manganese effects differently, such as increased staining or filter loading, depending on their tap water manganese load.

Second or Seasonal Homes Should Verify Water Quality Independently

Water conditions can change over seasons or years. Properties not used year-round may see different manganese concentrations and require separate water assessments.

Why Aesthetic Secondary Standards Differ from Health Limits

Manganese Impacts Appearance Not Direct Health

Manganese in water primarily affects color and staining rather than posing a direct health risk at levels measured here. Secondary standards focus on taste, discoloration, and appliance staining, which vary in importance by household.

Regulatory Thresholds Reflect Use Considerations

Federal guidelines establish limits to address these non-health effects separately from enforceable health standards. Understanding the distinction helps avoid unnecessary concern.

Source of Manganese in This Region's Groundwater

Natural Mineral Leaching Is the Primary Contributor

Manganese occurs naturally as groundwater passes through soil and rock formations in this aquifer, dissolving trace minerals without any human contamination indicated.

Depth and Geology Influence Concentration Levels

Variations in well depth and local geology explain differences between sampled wells, as shallower versus deeper wells may encounter different manganese content.

Conclusion: What CT Homeowners Should Keep in Mind

Area Sampling Does Not Define Individual Well Water Quality

Government data provides valuable context but does not substitute for direct testing of your home water supply to know actual manganese content.

Detected Manganese Within Federal Limits Means No Automatic Health Concern

While manganese is detected in this aquifer, no data from the area wells shows levels exceeding federal health thresholds, so concern about health effects from manganese alone is unsupported by these samples.

Choosing Treatment Depends on Your Specific Water Conditions

For those seeking manganese reduction, the Autotrol Black Manganese Stains Filter ships ready to configure and uses proven methods to address manganese and related staining issues when home water tests confirm need.

Where this information comes from

Source: USGS groundwater sampling. Sampled 2017-09-07. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.

On record: U.S. Geological Survey sampling of Manganese in the 112DFSF aquifer (FIPS 140): 5 results from 4 wells, median 1.85 ug/L, range 0.29-2.47 ug/L; none above any federal threshold