Autotrol Dry, Itchy Skin System

Buy Now

View full details

If your skin feels dry after water use at home, what do government water hardness records show?

The U.S. Geological Survey sampled 24 wells across Pottawatomie County from 2011 to 2013 in aquifer 310WLNG. Every sample detected hardness levels ranging from 12.2 to 364.0 mg/L, with a median of 62.0 mg/L. No sample exceeded federal safety thresholds, which are designed to protect health. Because hardness is a measure of calcium and magnesium, it mainly affects skin texture and comfort rather than safety.

If you read these median and range hardness numbers as a homeowner, how might they relate to dry skin?

A median hardness around 62 mg/L indicates that water in much of the area contains moderate calcium and magnesium levels. Some wells showed much softer water (12.2 mg/L) while others showed very hard water (up to 364 mg/L). Households with harder water might notice more skin dryness or irritation after bathing. These values do not indicate any health risk but relate more to skin feel and soap performance.

If the maximum hardness found stays below federal safety thresholds, what does that mean about your water?

The federal thresholds for hardness control aesthetic concerns like staining and scaling but are not health limits. Since none of the Pottawatomie County samples came close to a health-based limit, the presence of hardness does not signal unsafe water. It means your water quality falls within typical ranges that might cause dry skin but not pose health dangers.

If you want treatment, how should you estimate the capacity needed based on your household water use?

Your water use—measured in gallons per day—determines how much conditioning capacity you require. Larger households or frequent water users need systems capable of handling higher volumes before regeneration. The Autotrol Dry, Itchy Skin System ships ready to configure to match your daily demand, helping balance effective treatment with system capacity.

If wells in the area sampled range from 80 to 320 feet deep, how might your well depth affect your water hardness?

Water hardness can vary with well depth, aquifer characteristics, and local geology. The samples here represent a variety of well depths, so your well water may be softer or harder depending on its own conditions. Only a test of your specific water can determine its actual hardness and suitability for treatment.

If the area record shows all samples detected hardness, with median and range values, what do those terms mean?

• Detected means the instruments found measurable calcium and magnesium in every sample.
• Median is the middle value, showing that half the wells had hardness below 62 mg/L and half above.
• Range expresses the spread from the softest (12.2 mg/L) to the hardest (364 mg/L) water found across wells.

This data describes the general area and aquifer, not your specific well or tap water.

Closing: What should you NOT conclude from these area water data?

Do not assume your household water has the median or any specific hardness value reported here. Area sampling cannot replace a laboratory test of your own water. Detection is not a violation or indication of unsafe water, and hardness does not imply health risk. Use this data as background context only, and consider testing your water before selecting treatment. The Autotrol Dry, Itchy Skin System is designed to address the effects of moderate to high hardness levels on skin, but correct sizing requires your water’s actual hardness and household consumption.

Where this information comes from

Source: USGS groundwater sampling. Sampled 2013-05-01. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.

On record: U.S. Geological Survey sampling of Hardness, Ca, Mg in the 310WLNG aquifer (Pottawatomie County): 24 results from 24 wells, median 62.0 mg/L, range 12.2-364.0 mg/L; none above any federal threshold