Autotrol Complete Well System

Buy Now

View full details

1. Begin by Excluding Simple Causes Before Advanced Testing

It is common to assume that complete well water issues immediately indicate a contamination emergency. However, many apparent problems stem from routine system checks. Start by confirming all visible equipment and plumbing components are functioning properly at home, as some mechanical faults can mimic water quality problems. If these checks do not reveal issues, the next step involves sampling and laboratory analysis of your specific well water to understand its unique composition.

2. How the Autotrol System Addresses Total Dissolved Solids

Data collected by the U.S. Geological Survey for wells in Waushara County’s 100SDGV aquifer report total dissolved solids (TDS) with a median of 188 mg/L, a measure of minerals and salts dissolved in the water. While most regional samples are below secondary aesthetic guidelines of 500 mg/L, two results slightly exceeded this level. Elevated TDS can affect water taste and cause minor staining but is not a health risk. The Autotrol Complete Well System uses technology designed to reduce these dissolved solids effectively, refining the water quality to improve household water aesthetics and functionality.

3. Interpreting the Range of Total Dissolved Solids Against Regulations

The documented range from 0.22 to 612 mg/L in local wells indicates natural variation in dissolved solids within the aquifer. The federal secondary standard for TDS at 500 mg/L is an aesthetic guideline, not a health-based limit. Detection of TDS above this value in some area wells does not imply water safety concerns. It merely denotes that some water sources may have mineral content influencing taste or appearance. Only a well-specific test can establish the exact TDS concentration for your household source, which is essential for deciding if treatment is needed.

4. Assessing Treatment Capacity Relative to Household Water Demand

The Autotrol Complete Well System features a grain capacity of 32,000 grains, indicating the amount of dissolved solids the system can manage before maintenance or regeneration is necessary. Considering daily water use, typical residential demand should be compared with this capacity to ensure the system adequately treats water without frequent servicing. Estimating your household’s water consumption helps in choosing a system sized to maintain water quality consistently over time.

5. Distinguishing Complete Well Issues from Commonly Mistaken Water Concerns

Complete well problems often get confused with issues like hard water or bacterial contamination. While hard water mainly relates to calcium and magnesium levels affecting scaling, and bacterial contamination concerns microbiological safety, complete well water issues focus on broader dissolved solids that impact taste and staining. The regional TDS data clarifies that high dissolved solids are an aesthetic matter distinct from health risks or hardness, helping steer towards appropriate treatment.

Conclusion: Regional data on total dissolved solids in Waushara County’s aquifer provides valuable context but should not lead to conclusions about your own well water’s specific condition or safety. Only direct testing of your water can inform precise treatment decisions. The Autotrol Complete Well System offers a tested approach to manage dissolved solids effectively, improving residential water quality when needed.

Where this information comes from

Source: USGS groundwater sampling. Sampled 2024-08-20. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.

On record: U.S. Geological Survey sampling of Total dissolved solids in the 100SDGV aquifer (Waushara County): 33 results from 7 wells, median 188.0 mg/L, range 0.22-612.0 mg/L; 2 above an AESTHETIC secondary standard only (secondary standard 500.0 mg/L (aesthetic)) - not a health finding