How Public-System Records Differ from Private-Well Testing in What They Establish
The U.S. Geological Survey’s sampling in Morehouse Parish focuses on wells 600 to 774 feet deep within aquifer 124SPRT. These results represent the general characteristics of groundwater in the area, not specific homeowner wells. Individual wells can vary from these averages. Only direct testing of your own water reveals its exact pH and hardness levels. Therefore, area data serve as a regional guide rather than a definitive statement about any single household’s situation.
The Household or Facility Symptoms That Do and Do Not Point to This Problem
Households experiencing issues with acid and hard water may notice mineral scale buildup on fixtures, reduced appliance efficiency, or water spots on dishes. Softening equipment failure may worsen these symptoms by no longer mitigating hardness minerals and acidity. However, symptoms like cloudy or discolored water have other causes and do not specifically indicate acid and hardness issues. Confirming the problem requires testing your well water’s pH and hardness, not relying solely on visible symptoms.
Why Aesthetic Secondary Standards Differ from Health-Based Limits, Applied to This Constituent
The Environmental Protection Agency’s secondary standard for pH ranges from 6.5 to 8.5 standard units and relates to water’s taste, staining potential, and corrosivity—not health risk. The government sampling here shows the pH consistently above 8.4, within or slightly above this aesthetic range, indicating mildly alkaline water rather than acidic. This standard is not a legal limit and does not imply safety concerns by itself. Acidic water, if present, would have a pH below 6.5, which was not detected in these area samples.
What 'Detected', 'Median' and 'Range' Mean in the Sampling Record on This Page
In the surveyed wells, pH was 'detected' in every sample, meaning the measuring instruments recorded values successfully. The median pH of 8.7 standard units represents the middle value among all samples taken from two wells over several years, while the range from 8.4 to 8.8 shows the lowest and highest recorded pH. These figures summarize regional water characteristics but do not specify conditions at any single well. Detection does not mean a problem exists, only that pH measurements were made.
What Happens When This Problem Is Left Untreated for Years, Stated Without Exaggeration
When acid and hardness issues persist without treatment, mineral deposits can build up inside pipes, water heaters, and appliances, reducing efficiency and lifespan. Slightly alkaline water, as indicated in Morehouse Parish’s area samples, may cause fewer corrosion problems but still contribute to scale formation. Over time, this can lead to higher maintenance needs or replacement of household equipment. Addressing acid and hardness water helps maintain plumbing integrity and water-using devices’ performance.
For households in Morehouse Parish whose existing water treatment equipment has failed, the Fleck Acidic Water + Hard Water (Well) System offers a documented solution. With a grain capacity of 32,000, it is designed to manage the combined challenges of acid and hardness in well water, helping restore water quality and protect household systems.
What You Should Not Conclude from Area Data
Do not assume that your well’s water matches the pH levels found in government samples of nearby deep wells. These data indicate trends in the local aquifer but cannot replace individual water testing, which is necessary to identify your water’s exact condition. Also, do not interpret the pH range as a health safety finding—this record relates to aesthetic and corrosion properties only. Confirm your water chemistry through analysis before making treatment decisions.
Where this information comes from
Source: USGS groundwater sampling. Sampled 2018-09-20. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.
On record: U.S. Geological Survey sampling of pH in the 124SPRT aquifer (Morehouse Parish): 22 results from 2 wells, median 8.7 standard units, range 8.4-8.8 standard units; EPA secondary standard for pH is 6.5-8.5 (aesthetic/corrosivity, not health-based); 0 of 22 sampled results fell below 6.5
- ✓ 90-Day Money-BackNo restocking fees — return within 90 days.
- ✓ Manufacturer WarrantyGenuine Fleck · Pentair · VIQUA equipment.
- ✓ Free Expert SizingTalk to a specialist and buy the right system the first time.