Fleck Sensitive Skin & Eczema System

Buy Now

View full details

1. A Worked Example: Reading the Record's Median and Range as a Homeowner Would

Government groundwater sampling in Richmond County, specifically from aquifer 125DBMV, involved nine hardness measurements taken between 2010 and 2025 from two wells drilled 325 to 335 feet deep. The median hardness was 2.28 mg/L, with values ranging from 1.52 mg/L to 3.8 mg/L.

For a homeowner concerned about sensitive skin, these numbers reflect the calcium and magnesium levels typical of the regional aquifer but do not represent the exact conditions of your home's water. This area data serves as a backdrop to anticipate water characteristics in Richmond County but does not replace an individual water test to understand your water quality precisely.

2. How the Treated Water Differs at the Tap Once the Documented Technology Is in Place

When using the Fleck Sensitive Skin & Eczema System, water hardness is addressed by reducing calcium and magnesium ions associated with hardness. This system ships ready to configure with a grain capacity of 32,000, which is sized to provide continuous softened water suitable for households prioritizing skin comfort.

Post-treatment water tends to be gentler on sensitive skin by lowering mineral content that can contribute to dryness or irritation. The system's design ensures a consistent condition at the tap without the need for specialized setups, promoting skin hydration and reducing potential irritation related to hardness.

3. What 'Detected', 'Median' and 'Range' Mean in the Sampling Record on This Page

In the government sampling data, 'detected' indicates that the measuring instruments found calcium and magnesium in all nine samples; none were below reporting limits. The 'median' value (2.28 mg/L) represents the middle value in the ordered dataset, offering a central tendency of hardness. The 'range' (1.52 to 3.8 mg/L) shows the lowest and highest values measured, illustrating some natural variation within the aquifer.

None of these values exceed any federal threshold for hardness or related constituents. Detection does not imply a water safety issue but informs the water's mineral composition relevant to skin sensitivity. Knowing these terms helps homeowners interpret regional data without assuming it matches their specific water.

4. How to Compare This Area's Record with a Neighboring County's Without Overreading It

When comparing Richmond County's aquifer 125DBMV data to that of adjacent counties, it is important not to assume that similar figures apply directly to your home's water. Each aquifer and well can vary significantly due to depth, local geology, and other factors.

For example, a neighboring county might show a slightly higher or lower median hardness, but this does not definitively predict your water condition. Use regional data as a guide rather than a direct measurement. A personal water test remains invaluable for sizing and selecting water treatment equipment effectively for sensitive skin considerations.

5. What Changes for a Large Household, a Second Home, or a Seasonal Property

Household size and water usage influence how the Fleck Sensitive Skin & Eczema System should be sized. Larger households or properties with higher water demand require equipment with sufficient grain capacity to maintain performance without frequent recharge cycles.

For seasonal properties or second homes with intermittent use, sizing can consider lower daily consumption but should account for occasional heavy usage to avoid saturation of the treatment media.

The documented 32,000 grain capacity of the Fleck system provides a balance suitable for many typical residential uses, but adjusting based on household size and usage patterns ensures optimal comfort for sensitive skin.

Summary

This briefing clarified the limits of regional water data from Richmond County's aquifer 125DBMV for assessing sensitive skin concerns and emphasized the importance of testing your own water.

It also explained how the Fleck Sensitive Skin & Eczema System addresses mineral content affecting skin comfort and how to size it according to household demand without overreading area data.

Where this information comes from

Source: USGS groundwater sampling. Sampled 2025-07-09. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.

On record: U.S. Geological Survey sampling of Hardness, Ca, Mg in the 125DBMV aquifer (Richmond County): 9 results from 2 wells, median 2.28 mg/L, range 1.52-3.8 mg/L; none above any federal threshold