Pentair Radon in Water Filter

Buy Now

View full details

If you compare regional groundwater sampling with private well tests

The U.S. Geological Survey has measured radon-222 in St. Lawrence County's aquifer 367BKMN, gathering results from 11 samples taken between 2010 and 2020 from wells 60 to 280 feet deep. These show radon was always detected, ranging from 137.0 to 1440.0 pCi/L, with a median value of 239.0 pCi/L. While this data represents the area aquifer, it does not show the radon level in your specific well or home water. No sample from this set exceeded any federal limit.

Area data helps indicate whether radon is commonly present in local groundwater but cannot replace direct testing of your home water supply, as concentrations can vary significantly between wells.

If you consider which household water uses reveal radon effects first

Radon dissolves in water and is released when water is agitated or heated. Fixtures like showers, hot water taps, and water heaters tend to show radon’s presence first because radon escapes into indoor air during these uses. This can contribute to airborne radon levels inside your home.

Certain water processes that increase water agitation or temperature accelerate radon release, so those fixtures are practical indicators of radon presence in water but cannot quantify concentration by themselves.

If you observe variation over time reflected in the regional record

The samples collected from 2010 through 2020 display a wide radon range across wells, from 137.0 to 1440.0 pCi/L, reflecting natural fluctuations. This long measurement period captures seasonal and multi-year variation in groundwater radon. Variations can result from changes in groundwater flow, aquifer conditions, or geologic factors influencing radon release.

Understanding these temporal fluctuations helps homeowners appreciate that radon levels in their well water may also vary over time.

If you consider what a certified lab test for radon in water reports

A certified laboratory test measures radon concentration in your water in picocuries per liter (pCi/L), the same unit used in the USGS regional data. Your test report will show a numerical radon level specific to your water supply at the time of sampling.

Interpreting your test requires comparing it with federal guidance levels and regional data. Only a direct test of your well water can establish your household radon level accurately.

If you want to understand radon sources in St. Lawrence County groundwater

Radon in the area aquifer primarily originates from the natural decay of uranium in local rocks and soil. It dissolves into groundwater as it moves through these materials. The geology of aquifer 367BKMN influences radon levels, explaining why multiple wells in the same area show detectable radon.

This geological background means radon presence in water is common in this region but varies well-to-well due to local conditions.

Conclusion: The critical test and treatment consideration

The most important step is ordering a certified laboratory radon test of your own water supply to determine your household concentration precisely. If the test results indicate elevated radon levels that concern you, systems such as the Pentair Radon in Water Filter ship ready to configure to reduce radon in water effectively.

Relying on local aquifer data alone is not sufficient for treatment decisions but provides valuable context about the likelihood of radon presence in your area’s groundwater.

Where this information comes from

Source: USGS groundwater sampling. Sampled 2020-07-23. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.

On record: U.S. Geological Survey sampling of Radon-222 in the 367BKMN aquifer (St. Lawrence County): 11 results from 10 wells, median 239.0 pCi/L, range 137.0-1440.0 pCi/L; none above any federal threshold