24 Steel Tanks - Twin Unit Skid

Buy Now

View full details

Hard water is often assumed to be a simple problem that can be estimated by appearance or taste. However, in industrial settings, accurately understanding water hardness is critical for equipment longevity and process efficiency. Misreading hardness levels without precise data can lead to ineffective equipment choices.

If your site requires regular, straightforward maintenance

The 24 Steel Tanks - Twin Unit Skid system is designed with a maintenance rhythm that balances industrial demands with operational simplicity. This commercial system skid ships ready to configure and requires periodic service checks on its components to maintain optimal performance. Its twin-unit design helps ensure continuous hardness removal without the need for frequent intervention, making it suitable for facilities where downtime must be minimized.

If you want to interpret local water hardness data accurately

The U.S. Geological Survey sampled groundwater in Connecticut’s FIPS 180 area, specifically aquifer 110AVTN, recording hardness concentrations from 140.0 to 188.0 mg/L with a median of 162.5 mg/L. These four samples, collected from wells 2 feet deep between March 2010 and February 2011, demonstrate the typical hardness range industrial users might expect in this region’s groundwater but do not measure any individual well’s water.

If treated water quality differences matter to your process outcomes

Once the 24 Steel Tanks - Twin Unit Skid system is in operation, the water hardness at the tap is significantly reduced, helping prevent scale buildup in industrial equipment and pipelines. This results in improved heat transfer efficiency, less frequent maintenance needs, and longer service life for machinery dependent on treated water. The system’s design ensures consistent water softening that adapts to varying hardness levels within the sampled regional range.

If you need clarity on the terminology used in water hardness data

• Detected: Hardness measurements found presence above the reporting limit but do not indicate any health or safety issue.
• Median: The middle value in the set of hardness measurements, representing a typical concentration.
• Range: The span from the lowest to the highest detected hardness level, showing natural variation within sampled wells.

If you want to understand the significance of these hardness values compared to standards

None of the sampled groundwater hardness values in this area exceed federal thresholds. Hardness itself is a secondary water quality measure influencing taste, scaling potential, and equipment impact rather than a health-based violation. This means the data reflects typical regional groundwater conditions without indicating unsafe water quality.

If you are considering how water hardness may change over time in this region

The data collected over nearly a year, from early 2010 through early 2011, shows a consistent range of hardness levels. This suggests that seasonal and short-term variations in hardness are relatively stable within aquifer 110AVTN, offering confidence in equipment sizing and selection based on these metrics.

These data points represent groundwater samples from aquifer 110AVTN in Connecticut’s FIPS 180 area only and do not directly measure any specific industrial site’s water. For precise water hardness values at your location, individual testing is necessary. For more detailed regional information, visit the U.S. Geological Survey groundwater data page referenced here.

Where this information comes from

Source: USGS groundwater sampling. Sampled 2011-02-20. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.

On record: U.S. Geological Survey sampling of Hardness, Ca, Mg in the 110AVTN aquifer (FIPS 180): 4 results from 1 wells, median 162.5 mg/L, range 140.0-188.0 mg/L; none above any federal threshold