Fleck Blue-Green Copper Stains Filter

Buy Now

View full details

Laboratory Test Reports for Copper: What They Include

Laboratory reports measuring copper in water typically list concentrations in micrograms per liter (ug/L). For Nemaha County's 112DRFT aquifer, the U.S. Geological Survey collected 15 samples from 14 separate wells, with depths ranging from 18 to 69 feet, between August 3 and August 25, 2011. Copper was detected in 5 of these samples with a median of 0.58 ug/L and a range between 0.51 and 1.7 ug/L. Ten samples were below the reporting limit, indicating very low copper presence in most cases. No federal health-based thresholds were exceeded in this data.

Sample Depth and Well Type: Influences on Expected Copper Levels

How deep wells are and their source type can affect copper concentrations. Shallower wells might interact differently with soils and materials than deeper wells, influencing copper presence. The sampled wells in this area spanned from 18 to 69 feet in depth, suggesting that copper levels may vary within this range. Household water sourced from similar depth wells might reflect these variations. Understanding your own well's depth and source type is important to anticipate copper behavior and potential staining issues.

Comparing Nemaha County's Copper Records With Neighboring Areas

When reviewing copper data, it is tempting to compare Nemaha County's levels with those of nearby counties. However, slight differences in geology, aquifer characteristics, and well construction can cause variation. The median copper detected here (0.58 ug/L) falls within a low range that should not be overinterpreted as problematic. Neighboring counties may have similar or slightly different copper measurements, but without individual well testing, wide generalizations are unreliable for treatment decisions.

Sample Size and Data Strength: What 15 Samples Tell Us

Fifteen samples from fourteen wells provide a snapshot of copper concentrations in this aquifer but are limited in scope. The fact that copper was detected in only a third of these samples and below reporting limits in the majority points to generally low presence. A small sample size like this means household water could differ, making private well testing essential. These measurements provide regional context but do not define any one home's water quality.

Preparing for Treatment Advice: What to Note Before Deciding

Before choosing a way to manage copper staining, note these details about your water system:

• Well depth and aquifer source
• Results from a laboratory copper test of your own water
• Presence of visible blue-green stains on fixtures or laundry
• Any history of plumbing corrosion or materials used

Having this information available helps tailor treatment choices effectively rather than relying only on area data which may not fully apply.

How the Fleck Blue-Green Copper Stains Filter Works on Copper

The Fleck Blue-Green Copper Stains Filter is designed to address copper from water sources like those in Nemaha County’s aquifer 112DRFT. It works by intercepting copper ions before they can deposit on surfaces, thereby reducing or preventing blue-green staining in the home. This system ships ready to configure for household water demands and is effective where copper is present within the low detection range reported by government sampling.

Choosing this technology after confirming your water's copper content with a lab test and measuring your household’s daily water use supports targeted treatment that matches your specific needs.

Where this information comes from

Source: USGS groundwater sampling. Sampled 2011-08-25. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.

On record: U.S. Geological Survey sampling of Copper in the 112DRFT aquifer (Nemaha County): 15 results from 14 wells, median 0.58 ug/L, range 0.51-1.7 ug/L; none above any federal threshold