What does a laboratory report for total dissolved solids (TDS) in Rockingham County wells show?
The U.S. Geological Survey collected groundwater samples from aquifer 112ICCC in Rockingham County between March 2014 and August 2019. Across 138 results from a single well, measured TDS ranged from 0.49 to 429.0 mg/L with a median value of 362.0 mg/L. All measurements were below federal thresholds for TDS, indicating no compliance violations in this dataset. This report represents regional groundwater conditions, not your specific well.
How should I compare Rockingham County's water data with nearby areas without overreading it?
Differences in TDS levels between counties or aquifers can arise from local geology, water table depth, and human activity. While Rockingham County's aquifer 112ICCC data shows a median of 362.0 mg/L, neighboring aquifers might report higher or lower values. However, regional differences do not determine your household's water quality. Your well's water requires individual testing to know exact conditions because local variations and well construction significantly affect results.
How do public water system records differ from testing private wells for determining water quality?
Public water systems routinely monitor water quality to meet regulated standards and share this information publicly. These records reflect the water delivered to customers but may include treatment before distribution. Private wells are the responsibility of homeowners to sample and test independently. Therefore, municipal records from Rockingham County or other sources provide a background but do not substitute for specific well tests when deciding on water treatment options.
How does the Fleck Complete Well System remove or neutralize total dissolved solids?
The Fleck Complete Well System is designed to address a range of dissolved minerals and other constituents commonly found in private well water. With a grain capacity of 32,000, it uses filtration and ion exchange mechanisms to reduce total dissolved solids and improve water quality for household use. This system ships ready to configure, so you can set it up to match your well’s needs once you have water test results.
What happens if high total dissolved solids are left untreated in household water long term?
While all sampled results in Rockingham County's aquifer 112ICCC are below federal TDS thresholds, elevated TDS over time can cause taste issues, scale buildup in pipes and appliances, and potential staining on fixtures. These effects are primarily aesthetic and operational rather than health-related. Addressing TDS can improve water clarity and household plumbing longevity, but untreated water with TDS within regulatory limits is not a safety concern.
How can I interpret the record’s reported median and range of TDS as a homeowner?
The median TDS concentration of 362.0 mg/L indicates that half of the sampled values in the area are below this level and half above. The range—from 0.49 to 429.0 mg/L—shows natural variability within the aquifer’s water. Your own well might fall anywhere within or outside this range. To plan appropriate treatment, testing your water’s current TDS is essential rather than relying solely on regional data.
Once treated with the Fleck Complete Well System, how will my water differ at the tap?
With the Fleck Complete Well System active, water at your tap should have reduced total dissolved solids, resulting in improved taste and less mineral residue on surfaces. Appliances and plumbing components may benefit from fewer mineral deposits, potentially extending their service life. The system’s capacity and design work to maintain consistent water quality as you use your household supply.
The data presented here is based on groundwater samples from aquifer 112ICCC in Rockingham County collected by the U.S. Geological Survey between 2014 and 2019. For current and precise information about your water, testing your well is recommended. Data source: https://waterdata.usgs.gov/monitoring-location/425311070535801/.
Where this information comes from
Source: USGS groundwater sampling. Sampled 2019-08-22. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.
On record: U.S. Geological Survey sampling of Total dissolved solids in the 112ICCC aquifer (Rockingham County): 138 results from 1 wells, median 362.0 mg/L, range 0.49-429.0 mg/L; none above any federal threshold
- ✓ 90-Day Money-BackNo restocking fees — return within 90 days.
- ✓ Manufacturer WarrantyGenuine Fleck · Pentair · VIQUA equipment.
- ✓ Free Expert SizingTalk to a specialist and buy the right system the first time.