Deciding which class of treatment your household needs for iron bacteria this week involves understanding the local water data and what it means for your home's water quality.
What detected, median, and range mean in Leflore County's iron sampling record
The U.S. Geological Survey collected 24 iron measurements from 15 wells in Leflore County's aquifer 112MRVA between 2010 and 2020. Detected means every one of these samples showed some iron present; none were below the measurement limit. The median value of 9,035 micrograms per liter is the middle point of these iron results, showing a typical concentration in this area. The range from 19.6 to 20,300 micrograms per liter shows the full spread of what was found across different wells and depths from 28 to 220 feet. These figures reflect regional groundwater conditions, not any individual well’s water quality.
Maintenance rhythm of the Pentair Iron Bacteria & Slime Filter in plain terms
The Pentair system designed for iron bacteria treatment ships ready to configure for your home. Once in use, maintaining effective iron bacteria control involves periodic media replacement and system flushing based on water use and iron load, usually checked every few months to a year. This routine keeps the system operating efficiently without complex upkeep.
How treated water differs at the tap with the Pentair system
Water treated with this system shows a marked reduction in iron bacteria and slime presence, leading to clearer water that resists staining and slime buildup on fixtures. While this system addresses aesthetic and operational issues caused by iron bacteria, it does not change other water characteristics not related to iron. You can expect improved water clarity and less iron-related discoloration after treatment.
Reading the median and range from the record as a Leflore County homeowner
If you consider the median iron value of 9,035 micrograms per liter as typical for this area, your well's iron concentration might be similar, but only a specific water test can confirm this. The wide range from about 20 to over 20,000 micrograms per liter shows that iron levels can vary significantly from well to well. This variation means that treatment needs might differ, so knowing your well's actual iron level is key to selecting adequate treatment capacity.
What the measured range means against federal iron standards—and what it does not mean
None of the sampled wells in this area exceeded any federal threshold for iron, indicating that these iron amounts are not regulatory violations. Federal standards for iron primarily address taste and staining rather than safety. Measuring iron in your well water and understanding these natural regional levels helps you determine if treatment is needed for aesthetic or operational reasons rather than health concerns.
Choosing the right iron bacteria treatment involves interpreting area sampling data carefully, maintaining your treatment system to handle local iron levels, and understanding how treated water quality improves. The Pentair Iron Bacteria & Slime Filter offers a proven solution tailored to these factors, helping Leflore County homeowners manage iron bacteria with confidence.
Where this information comes from
Source: USGS groundwater sampling. Sampled 2020-07-23. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.
On record: U.S. Geological Survey sampling of Iron in the 112MRVA aquifer (Leflore County): 24 results from 15 wells, median 9035.0 ug/L, range 19.6-20300.0 ug/L; none above any federal threshold
- ✓ 90-Day Money-BackNo restocking fees — return within 90 days.
- ✓ Manufacturer WarrantyGenuine Fleck · Pentair · VIQUA equipment.
- ✓ Free Expert SizingTalk to a specialist and buy the right system the first time.