Fleck Spotty Dishes & Glassware System

Buy Now

View full details

1. Comparing Hempstead County's Water Data with Neighboring Areas

The U.S. Geological Survey samples groundwater from aquifer 212TOKO in Hempstead County, Arkansas. This data reflects multiple wells ranging in depth from 953 to 1191 feet. When looking at nearby counties, it’s important to note that their groundwater chemistry can vary naturally due to geology. Avoid assuming your well’s water quality matches either county’s average without testing. The Hempstead County data presents a specific regional snapshot and should be used as a point of reference, not a direct comparison.

2. Distinguishing Spotting Issues from Other Water Concerns

Spotting on dishes typically relates to minerals that leave residues after water evaporates. This is often confused with staining or cloudiness caused by iron or other elements not addressed here. The U.S. Geological Survey reports calcium and magnesium levels, which contribute to mineral deposits affecting dish appearance. This differs from organic or biological film deposits or detergent inefficiencies, which require separate approaches.

3. Understanding Detection, Median, and Range in the Sampling Record

In the Hempstead County aquifer data, calcium and magnesium were detected in all seven samples, with values spanning from 1.59 to 24.3 mg/L, and a median of 1.77 mg/L. "Detected" means these minerals were measured by instruments in every sample; it does not imply a water quality violation. The range shows the lowest and highest concentrations found among sampled wells, indicating variability in the aquifer. The median value provides a middle point that helps understand typical conditions in the area.

4. Seasonal and Multi-Year Variation in Measured Values

The samples collected between August 2011 and July 2025 show how mineral concentrations can fluctuate over time. These long-term data points highlight that water quality in this aquifer changes, possibly due to environmental factors or well depth differences. Such variation is normal and suggests your own water's mineral content may vary from year to year or season to season, underscoring the value of direct testing for your specific source.

5. Reading a Certified Laboratory Test Report for Mineral Content

A lab report for your well water will list concentrations of calcium and magnesium as milligrams per liter (mg/L), similar to the USGS data. Look for terms like "calcium hardness" or "magnesium hardness". This quantitative data will tell you your water’s exact mineral levels. Knowing these figures helps determine if mineral residue contributes to dish spotting in your household and guides whether treatment is needed.

6. Changes at Your Tap After Using the Fleck Spotty Dishes & Glassware System

Once water passes through the Fleck Spotty Dishes & Glassware System, it undergoes a process that reduces minerals causing water spots on dishes and glassware. The treated water leaves less residue upon drying, improving clarity and cleanliness. This system ships ready to configure, allowing you to connect it to your water supply and start seeing a difference in spot-free results soon after. It addresses the specific mineral challenges documented in Hempstead County’s aquifer.

The U.S. Geological Survey’s data describes mineral concentrations in multiple wells of aquifer 212TOKO within Hempstead County, Arkansas, based on samples collected between 2011 and 2025. For more information, visit the government source at waterdata.usgs.gov.

Where this information comes from

Source: USGS groundwater sampling. Sampled 2025-07-25. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.

On record: U.S. Geological Survey sampling of Hardness, Ca, Mg in the 212TOKO aquifer (Hempstead County): 7 results from 3 wells, median 1.77 mg/L, range 1.59-24.3 mg/L; none above any federal threshold