Fleck Complete Well System

Buy Now

View full details

If you see few samples but varying TDS levels in Osage County wells

The U.S. Geological Survey collected 12 total dissolved solids (TDS) measurements from five separate wells in Osage County’s aquifer 322VMOS during 2016. These wells ranged from 80 to 210 feet deep. While the median TDS was about 46 mg/L, the results ranged widely between 0.13 and 643 mg/L. This small sample size means the data provides useful but limited insight into the aquifer's general water quality rather than your specific well’s condition.

If you consider how total dissolved solids enter groundwater in Osage County

TDS in Osage County groundwater derives from natural mineral deposits and possibly some human activities that introduce dissolved salts and minerals. These dissolved solids affect taste and can cause staining in plumbing or fixtures beyond certain aesthetic secondary standards. They do not indicate health risks below regulated limits. Understanding this origin helps anticipate what treatment steps will be necessary for your household water.

If you wonder what terms like 'detected', 'median', and 'range' mean for these samples

“Detected” means the TDS level was measurable in all samples, never below the instrument’s reporting limit. The “median” is the middle value when all samples are ordered, showing a central tendency of about 46 mg/L for this area. The “range” indicates the difference between the lowest and highest values, here from 0.13 to 643 mg/L, demonstrating variability in groundwater composition among local wells.

If you want to know how the Fleck Complete Well System treats total dissolved solids

The Fleck Complete Well System uses a filtration and ion-exchange technology designed to reduce mineral concentrations that can cause taste or staining issues. It has a grain capacity of 32,000, reflecting its ability to treat larger quantities of dissolved minerals before regeneration is needed. This system ships ready to configure for residential well water setups, addressing varied TDS levels effectively.

If you want to understand treated water quality after using the Fleck Complete Well System

Once treatment with the Fleck system is in place, water typically shows improved taste and reduced potential for surface staining by minerals. The system targets secondary aesthetic issues associated with TDS rather than health-based contaminants. Users can expect more consistent water quality that aligns better with household preferences for appearance and flavor.

If you consider how sample depth and source influence your water expectations

Sampling from wells between 80 and 210 feet suggests aquifer conditions at moderate depths. Wells in this range can vary widely in TDS depending on local geology and flow paths. Deeper wells might show different concentrations. Therefore, your specific well depth and source type matter when evaluating how representative these area data are for your water and the sizing of treatment equipment.

Conclusion: Area sampling data provide a valuable overview but do not reveal your well’s exact water quality. Only a test of your own well will establish its specific total dissolved solids concentration. The Fleck Complete Well System offers a documented, direct-purchase option to address aesthetic water conditions common in Osage County’s aquifer 322VMOS, helping you size treatment equipment appropriately based on your household’s needs and water test results.

Where this information comes from

Source: USGS groundwater sampling. Sampled 2016-07-11. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.

On record: U.S. Geological Survey sampling of Total dissolved solids in the 322VMOS aquifer (Osage County): 12 results from 5 wells, median 46.435 mg/L, range 0.13-643.0 mg/L; 4 above an AESTHETIC secondary standard only (secondary standard 500.0 mg/L (aesthetic)) - not a health finding