When considering treatment for a complete residential well in Oakland County drawing from aquifer 112OTSH, it’s important to understand what regional water quality data can and cannot reveal about your well's water. Publicly available monitoring from the U.S. Geological Survey offers insights into total dissolved solids (TDS) levels across multiple wells sampled in the area. However, these figures do not establish the quality of any individual well, including yours. Testing your specific water is necessary for an accurate assessment.
What is the best way to determine your well’s water quality before choosing treatment?
Start by ruling out external or systemic influences such as plumbing materials or recent changes in well construction. Next, consider a certified laboratory test for your water, focusing on constituents like total dissolved solids among others. This test data will provide the precise concentrations relevant to your household’s needs and help in selecting appropriate treatment equipment.
How does the Autotrol Complete Well System address total dissolved solids?
The documented Autotrol Complete Well System is designed to manage water with a grain capacity of up to 32,000 grains, efficiently reducing the effects of dissolved solids that may impact taste, staining, or corrosivity. By softening and filtering water, it improves overall water quality where aesthetic concerns arise from elevated total dissolved solids. This system ships ready to configure for your household’s plumbing setup.
Are there additional questions commercial or industrial water users should consider that differ from household concerns?
Commercial and industrial operators often require detailed water quality profiles covering a broader range of constituents and higher volume capacities. They also must consider regulatory compliance and process-specific requirements, which are beyond the typical residential scope. Households primarily focus on aesthetic and general water quality improvements.
What do the terms 'detected,' 'median,' and 'range' mean in the regional sampling record?
- Detected: This means total dissolved solids were measured in every sample from the 16 wells over the sampling period (2010 to 2016). ‘Detected’ does not signify a safety issue.
- Median: The middle value of the measurements was 438 mg/L, indicating a typical concentration observed across the samples.
- Range: The samples varied widely from 0.24 to 1870 mg/L, showing some wells had much higher levels than others in the region.
What information should you record before seeking treatment advice?
Document the results of your certified water test, including concentrations of total dissolved solids and other relevant constituents. Record your well depth, well construction details, and any noticeable water quality issues. This information helps clarify your conditions and supports recommending the correct treatment approach.
How can a residential homeowner interpret the median and range from the area data?
As a homeowner, understand that a median TDS value near 438 mg/L suggests average regional water quality in the aquifer. The broad range up to 1870 mg/L indicates there are localized variations. Your well’s TDS level could be below, near, or above this median, which only your test can confirm. This underscores why area data provides context but not a definitive answer for your specific situation.
In conclusion, while Oakland County's aquifer sampling record gives a valuable snapshot of water quality trends, it cannot substitute for a focused evaluation of your own well. Do not assume that detected levels or aesthetic thresholds reflect a safety issue or apply exactly to your water. Use these data to guide your testing priorities and consider the Autotrol Complete Well System as a documented treatment capable of addressing aesthetic concerns related to total dissolved solids on a residential scale.
Where this information comes from
Source: USGS groundwater sampling. Sampled 2016-09-27. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.
On record: U.S. Geological Survey sampling of Total dissolved solids in the 112OTSH aquifer (Oakland County): 54 results from 16 wells, median 438.0 mg/L, range 0.24-1870.0 mg/L; 20 above an AESTHETIC secondary standard only (secondary standard 500.0 mg/L (aesthetic)) - not a health finding
- ✓ 90-Day Money-BackNo restocking fees — return within 90 days.
- ✓ Manufacturer WarrantyGenuine Fleck · Pentair · VIQUA equipment.
- ✓ Free Expert SizingTalk to a specialist and buy the right system the first time.