If You Look at the Uranium Data for Douglas County, What Does It Tell You?
The U.S. Geological Survey has sampled 24 wells in Douglas County tapping into aquifer 112SDGVD between 2010 and 2025. In these samples, uranium was detected every time, with a median concentration of 4.49 micrograms per liter and a range from 0.052 to 110.0 micrograms per liter. This means uranium is commonly present in the groundwater in your area, though none of these measurements exceeded any federal thresholds designed to guide safe levels.
If You Wonder Which Household Water Uses Are Most Exposed to Uranium and Radium?
Water used for drinking, cooking, and bathing directly exposes residents to dissolved uranium and radium when present. Since these contaminants travel through the water supply, fixtures such as kitchen taps and bathroom sinks are primary points of contact. Appliances like ice makers or water heaters also receive this water, potentially affecting their lifespan or requiring extra attention. Understanding which uses involve the most exposure helps plan targeted water treatment steps.
If You Think About How Many Wells and Samples Back This Area’s Uranium Data?
The record draws on 97 samples taken from 24 wells ranging from 22 to 246 feet deep. This diversity offers a broad picture of the aquifer’s general uranium content across Douglas County. However, it is important to note that these figures represent regional data: your household well could differ significantly due to local geological variations or depth differences. This context means you should consider your own water testing to understand your specific water quality.
If You Get a Certified Laboratory Test for Uranium or Radium in Your Water, How Should You Read It?
A certified lab test will report uranium concentration in micrograms per liter (ug/L). These results allow you to compare your specific water against the regional median and range documented here. A reading within the regional range suggests typical aquifer levels, but confirmation with federal guidance ensures safety margins. Knowing your test numbers helps decide if and what kind of treatment might be appropriate for your household.
If You Wonder How to Decide What to Do First About Uranium and Radium in Your Water?
- Start with an inexpensive basic water test at a certified lab that includes uranium and radium.
- Check all household water outlets for changes in taste or appearance, although uranium and radium often have no direct sensory clues.
- Review your home’s well depth and location compared to the regional data.
- If uranium or radium show measurable levels, consider equipment specifically designed to address these contaminants effectively, such as the C-Series Uranium & Radium System, which ships ready to configure and has a capacity of 32,000 grains.
If You Wonder What the Terms Detected, Median, and Range Mean in This Context?
In this record, 'detected' means the instruments found uranium in every tested sample, indicating a regular presence. 'Median' is the middle value of all samples—half had less uranium, half had more—here 4.49 ug/L. 'Range' shows the lowest and highest uranium readings recorded among wells, from 0.052 to 110.0 ug/L. These values frame the typical variation in Douglas County's aquifer but do not set safety or violation levels alone.
Deciding about uranium and radium in your household water starts with understanding regional data, learning which household uses are affected, and obtaining a certified lab test. With those steps, you can evaluate treatment options like the C-Series Uranium & Radium System to help manage your water quality.
Where this information comes from
Source: USGS groundwater sampling. Sampled 2025-06-13. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.
On record: U.S. Geological Survey sampling of Uranium in the 112SDGVD aquifer (Douglas County): 97 results from 24 wells, median 4.49 ug/L, range 0.052-110.0 ug/L; none above any federal threshold