Florence County, Wisconsin, draws groundwater primarily from the 100SDGV aquifer, where wells typically reach depths between 50 and 82 feet. This aquifer feeds residential wells supplying water to homes in the area. Groundwater flows through soil and geological formations before entering wells and household piping.
How will water from the Fleck Complete Well System differ at my tap?
Using the Fleck Complete Well System, water treated from a well in Florence County will have regulated levels of total dissolved solids (TDS) consistent with the system’s 32,000-grain capacity. While this system effectively manages mineral content that may affect taste, staining, or appliance lifespan, it does not alter water safety parameters beyond those addressed by local natural conditions. Treated water will typically have fewer dissolved minerals that cause hardness or scaling, leading to clearer, better-tasting water and reduced maintenance needs.
How do I judge if the treatment capacity matches my household’s daily water use?
The Fleck Complete Well System’s 32,000-grain capacity means it can handle a substantial mineral load before regeneration is needed. To size the system correctly, you should estimate your household’s average daily water consumption based on the number of users and typical usage patterns. This estimate can then be compared to the system’s specifications to ensure it will meet demand without frequent servicing or reduced efficiency. For example, families using higher volumes of water or having higher dissolved solids concentrations indicated by their own testing may require this capacity or greater. Remember, treatment capacity should exceed your daily mineral load to maintain effective water quality between servicing cycles.
What distinguishes Complete Well water problems from issues often confused with it?
Complete Well water problems focus on total dissolved solids and mineral content originating within the well source itself, which can impact water taste, clarity, and plumbing. This differs from surface water contamination or aging plumbing materials that may cause discoloration, odors, or bacterial concerns unrelated to dissolved mineral content. Furthermore, certain water characteristics commonly attributed to wells, such as hard water scale buildup, do not necessarily indicate contamination but relate to mineral content levels. Differentiating these concerns helps determine if complete well water treatment is the appropriate approach.
What happens if Complete Well water issues go untreated for years?
If total dissolved solids and related mineral content characteristic of Florence County’s aquifer are left untreated, homeowners may notice gradual scaling inside pipes, fixtures, and appliances. This buildup can reduce water flow efficiency, increase energy use, and shorten the lifespan of water heaters and other equipment. Additionally, there may be aesthetic issues such as cloudy water or taste changes. However, untreated TDS at concentrations observed regionally does not pose health risks since federal thresholds have not been approached by aquifer sampling.
What does the measured TDS range mean compared to federal standards, and what does it not imply?
U.S. Geological Survey samples from Florence County’s 100SDGV aquifer between September 10 and 12, 2024, found total dissolved solids values ranging from 0.12 to 165.0 mg/L with a median of 85.5 mg/L. None of these results exceed any federal drinking water thresholds, which means the mineral content is within acceptable aesthetic and health-based guidelines. It is important to note that detection of TDS does not indicate a violation or unsafe water; rather, it reflects naturally occurring dissolved minerals in groundwater. The federal limits associated with TDS primarily address taste, staining, and plumbing corrosion potential, not safety.
How do seasonal or multi-year variations appear in the regional TDS record?
The data collected in Florence County was taken over a short three-day period, so it provides a snapshot rather than long-term variation. However, repeated sampling over months or years generally shows some fluctuation in total dissolved solids related to changes in rainfall, groundwater recharge, and aquifer dynamics. It is normal for TDS concentrations to vary but remain within a range that does not surpass federal aesthetic guidelines. For definitive information on your well water, personal testing at different times of year can reveal site-specific trends.
What should I not conclude from the regional TDS data?
While the Florence County aquifer sampling offers useful context, it does not determine the quality of your well water directly. Individual well water requires specific laboratory testing to identify its unique mineral and contaminant concentrations. The regional data also do not imply any health risk or regulatory issue from detected total dissolved solids within the reported range. Therefore, sizing your treatment system, such as the Fleck Complete Well System, should be based on your own water analysis and daily water use rather than solely on local government measurements.
Where this information comes from
Source: USGS groundwater sampling. Sampled 2024-09-12. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.
On record: U.S. Geological Survey sampling of Total dissolved solids in the 100SDGV aquifer (Florence County): 6 results from 2 wells, median 85.5 mg/L, range 0.12-165.0 mg/L; none above any federal threshold
- ✓ 90-Day Money-BackNo restocking fees — return within 90 days.
- ✓ Manufacturer WarrantyGenuine Fleck · Pentair · VIQUA equipment.
- ✓ Free Expert SizingTalk to a specialist and buy the right system the first time.