If Your Water Test Report Lists Uranium Concentrations
Laboratory reports on uranium content typically give values as milligrams per kilogram or micrograms per liter depending on the analysis method. For Santa Fe County, New Mexico, government sampling from 10 wells in the aquifer designated S100RIOGRD collected between 2014 and 2015 consistently detected uranium in all 28 samples. These results ranged from 0.181 to 37.0 mg/kg, with a median value of 4.95 mg/kg. However, none of these measurements exceeded federal uranium standards for drinking water safety. It is important to remember, these figures represent median and range for the area aquifer, not a specific well's current reading. A household must still test its own water to know the exact uranium concentration present.
If You Compare What Area Data Shows Versus a Private Well Test
Publicly available uranium measurements are from multiple wells over a time span and capture regional aquifer conditions. In contrast, tests of a private household well provide one-time, specific data that reflect localized conditions and well depth within the aquifer. Area data serve as a baseline for potential uranium presence but do not reveal a household's actual water quality. Thus, relying solely on regional statistics cannot substitute for an individual test report when choosing water treatment methods.
If You Wonder How Often Treatment Maintenance Is Needed
The C-Series Uranium & Radium System, designed for residential use, typically manages a service capacity of up to 32,000 grains before requiring media replacement or rejuvenation. Maintenance frequency depends on household water usage and uranium levels found in testing. Regular monitoring of system performance is advised to sustain effective uranium and radium reduction over time. The system ships ready to configure without external service calls, supporting routine owner upkeep according to water consumption and treatment demand.
If You Are Reading Median and Range Data as a Homeowner
The median uranium concentration of 4.95 mg/kg means half of the samples fell below this value and half above. The range from 0.181 up to 37.0 mg/kg shows variability among different local wells, likely due to geological factors and well depth, which ranged from 80 to 800 feet in sample collection. This demonstrates uranium levels in the aquifer can fluctuate widely. Knowing this helps a homeowner understand that their well test might differ substantially from the regional median or maximum.
If You Want to Understand These Measurements in Light of Federal Limits
The federal uranium standard for drinking water exists to protect health, and none of the sampled results from Santa Fe County aquifer wells exceeded that limit. Detection does not imply exceedance or health risk by itself. The range simply notes what was measured across the area. A household’s own well test may be higher or lower, so decisions on treatment should consider personal results rather than regional figures alone.
If You Are Considering Plumbing Factors That Affect Water Quality
Water composition reaching taps may be influenced by the material and age of plumbing separate from source uranium levels. Corrosion or mineral buildup in pipes can alter metals and other constituents in water. Such plumbing-related changes are distinct from aquifer uranium content and require separate evaluation if water discoloration, taste, or deposits arise.
If You Are Ready to Choose a Water Treatment Approach for Uranium and Radium
The C-Series Uranium & Radium System offers a tested method to reduce uranium and radium from household water, sized to handle a grain capacity of 32,000 before media maintenance is needed. After your water test quantifies uranium levels and typical household water usage is estimated, this system can be configured to meet your treatment needs effectively, providing an option for ongoing uranium and radium management.
Where this information comes from
Source: USGS groundwater sampling. Sampled 2015-01-13. These figures describe groundwater sampled in this area. They are not a test of any individual private well - only a test of that well can establish its own water.
On record: U.S. Geological Survey sampling of Uranium in the S100RIOGRD aquifer (Santa Fe County): 28 results from 10 wells, median 4.95 mg/kg, range 0.181-37.0 mg/kg; none above any federal threshold